Enterasys Networks X-PeditionTM manual ETH0

System Alarms and Events

Table A-6 High Severity Alarms/Events (continued)

Module	Message	Description
ETH1_	The ISR could not be connected	This is internal configuration alarm occurs because the interrupt
DRIV		service routine (ISR) cannot be connected to the FastEthernet 2
		interface/driver, rendering FastEthernet port 2 unavailable.
ETH1_	Init string parse failure	This internal configuration alarm is due to the driver being unable to
DRIV		parse its initialization string, rendering FastEthernet port 2
		unavailable.
ETH1_	Unrecoverable error	The FastEthernet 2 chip on the motherboard has severe problems -
DRIV		a catastrophic failure. The most likely cause is a hardware failure.
		When this alarm occurs, FastEthernet port 2 is unavailable.
ETH1_	OS initialization failure	This internal configuration alarm occurs because the operating
DRIV		system initialization of the driver/interface cannot be completed,
		rendering FastEthernet port 2 unavailable.
ETH1_	Device not found	Most likely this occurs due to a hardware failure - the FastEthernet 2
DRIV		chip cannot be found on the PCI bus (of the motherboard). When this
		occurs, FastEthernet port 2 is unavailable.
ETH0_	The device is stuck in reset	The FastEthernet 1 chip on the motherboard has severe problems -
DRIV		it cannot come out of reset and the FastEthernet 1 driver/interface
		cannot be started. The most likely cause is a hardware failure. When
		this alarm occurs, FastEthernet port 1 is not available.
ETH0_	The ISR could not be connected	This internal configuration alarm occurs because the interrupt
DRIV		service routine (ISR) cannot be connected to the FastEthernet 1
		interface/driver, rendering FastEthernet port 1 unavailable.
ETH0_	Init string parse failure	This internal configuration alarm occurs because the driver could not
DRIV		parse its initialization string, rendering FastEthernet port 1
		unavailable.
ETH0_	OS initialization failure	This internal configuration alarm occurs because the operating
DRIV		system initialization of the driver/interface cannot be completed,
		rendering the FastEthernet 1 interface unavailable.
CLI	Failed to create session for web access	Failure to start session for the Web.
CLI	Failed to create session for console access	Failure to start session for the Web.
CLI	Failed to create session for telnet access	Failure to start session for console.
CLI	Failed to create session for telnet access	Failure to start session for Telnet.
CLI	Failed to enable Telnet server	Cannot start Telnet server because socket open failed.
CLI	Failed to enable Telnet server	Cannot start Telnet server because socket bind failed.
CLI	Failed to enable Telnet server	Cannot start Telnet server because socket listen failed.
CLI	Failed to enable Telnet server	Failure to enable the Telnet server.

CLI	CLI Config mode released by user
	<username>

A user exits Configuration mode.

CLI	CLI Config mode released by user
	<username>

An unknown user exits Configuration mode.

CLI	CLI config mode released by startup-config Configuration mode is released when the startup-config script
	finishes execution.

A-6 Alarms/Events, System Limits, and Standard ASCII Table