Enterasys Networks X-PeditionTM manual Configuration Examples, T1 Example, T1-PRI Isdn Example

Utilizing the Command Line Interface

•Virtual Interfaces:

–Loopback - Range 0 to 15. Interface type: Internal Loopback.

–Dialer - Range: 0 to 255, Interface type: Dialer.

–VPN - Range: 0 to 255, Interface type: VPN tunnel/Dialer.

–Multilink - Range: 1 to 32767, Interface type: VPN tunnel.

–Frame Relay DLCI - Range: 16 to 1007, Interface type: Serial/FR.

–Sub-interface: Each sub-interface correlates with a physical interface, ranging as follows: ATM, BRI, and Serial - 1 to 30, Fast/GigabitEthernet - 1 to 64. The sub-interface number is Port number.sub-interface number for single channel serial, port number.channelgroupnumber.subinterface number for multi-channel.

Configuration Examples

The following examples display minimal interface configuration:

•FastEthernet Example

interface fastethernet 1 + Begins configuring interface/port 1 no shutdown + Enables the interface

•T1 Example

controller t1 1/0 + Begins configuring controller on NIM card 1, port 0

channel-group 3 timeslots 1, 3-6, 12 + Maps timeslots 1, 3, 4, 5, 6, and 12 to channel group 3 no shutdown + Enables the interface

!

interface serial 1/0:3 + Configures channel group 3 defined above encapsulation ppp + Sets interface encapsulation type to PPP

no shutdown + Enables the interface

•T1-PRI (ISDN) Example

controller t1 1/0/0 + Begins configuring PRI NIM card 1, port 0 pri-group+ Enables ISDN, sets all timeslots to map to channel groups on NIM controller t1 1/0/0:23 + Maps T1 NIM to D-channel sub-interface isdn switch-typeprimary-ni+ Selects switch type

isdn pool-member 1 priority 100 + Adds a prioritized pool member to sub-interface

•Dialer Example

interface dialer 4 + Begins configuring dialer interface 4

ip address 11.1.2.2 255.0.0.0 + Sets IP address/subnet on dialer port dialer pool 5 + Sets dialer 4 to use pool 5. Its members are physical ports interface serial 2/0 + Configures serial interface on NIM card 2, port 0 encapsulation ppp + Sets interface encapsulation type to PPP

dialer pool member 5 + Serial 2/0 is now a member of dialer pool 5 and will eventually be used by dialer 4 no shutdown + Enables the interface

!

interface serial 2/1 + Configures serial interface on NIM card 2, port 1 encapsulation ppp + Sets interface encapsulation type to PPP

dialer pool member 5 + Serial 2/1 is now a member of dialer pool 5 and will eventually be used by dialer 4 no shutdown + Enables the interface

2-18 Managing the XSR