Enterasys Networks X-PeditionTM manual Dial-in Routing for Dial on Demand Example

Configuring DoD/BoD

Figure 10-12 Point-to-Point Topology

172.22.80.4

XSR-Toronto

172.22.85.1

Switched line

172.22.85.2

XSR-Andover

172.22.96.1

Dial-in Routing for Dial on Demand Example

The following commands configure dialer interface 1:

XSR(config)#interface dialer 1

XSR(config-if<D1>)#encapsulation ppp

XSR(config-if<D1>)#ip address 172.22.85.1

XSR(config-if<D1>)#ppp authentication pap

+Enforces authentication username XSR-Andover to map incoming calls on XSR Toronto

XSR(config-if<D1>)#dialer pool 1 XSR(config-if<D1>)#dialer remote-name XSR-andover

+Specifies the authenticated username

XSR(config-if<D1>)#no shutdown

The following command configures authentication of the remote user:

XSR(config)#username XSR-andover password secret 0 code

The following commands add a dialer pool member and set the Central Office switch type on BRI port 1/0:

XSR(config)#interface bri 1/0

XSR(config-if<BRI-1/0>)#isdn switch-type basic-net3

XSR(config-if<BRI-1/0>)#dialer pool-member 1

XSR(config-if<BRI-1/0>)#no shutdown

Dial-out Routing for Dial on Demand Example

The following commands define a dial group, add a dial pool, specify a secret password to be sent to the peer for PAP authentication, and configure Dialer interface 1 with spoofing enabled on XSR-Andovernetwork:

XSR User’s Guide 10-27