Enterasys Networks X-PeditionTM manual Shutdown command

		System Alarms and Events
Table A-7 Medium Severity Alarms/Events (continued)
Module	Message	Description
ETH0_	PHY write operation unsuccessful	The PHY chip on the FastEthernet 1 interface has had an error (other
DRIV		than time-out) while processing a write request. When this occurs, port
		functionality may or may not be affected. The port will still be available,
		but its functionality may be diminished. The cause of this alarm is most
		likely HW failure.
DIAL	Dial muxIoctl call fail	Failure of the serial driver of the physical port connected to the
		modem.
DIAL	Modem on intf # is not responding	The modem is not connected or powered on.
DIAL	Invalid init string for modem on intf #	The modem does not recognize the initialization string. You should
		check the modem specification for a proper setup.
DIAL	Number busy for modem on intf #	The remote site dialed number is busy.
DIAL	No dial tone for modem on intf #	There is no dial tone for the modem PSTN line.
DIAL	No carrier for modem on intf #	The remote modem is not present at the site called by the local
		modem.
DIAL	No answer for modem on intf #	The remote modem is not configured for autoanswering.
DIAL	Connection dropped for modem on intf#s	The phone line connection is disconnected by the PSTN.
DIAL	Hangup fail for modem on intf #	Failure of the disconnect from the phone line command to the modem.
DIAL	Connection closed for modem on intf #	The phone line disconnect command is successful.
DIAL	Dialup connection opened for modem on	The modem has successfully built a phone line link with the remote
	intf #	site.
CLI	Failed to create session for Telnet access	Telnet session could not be created at this time.
CLI	Unrecognized parameter <parameter	Invalid parameters from initialization configuration file during boot
	string> at line <line #> in <file>	process. This file is different from the startup.cfg.
FR	serial a/b:d, started	Result from no shutdown command
FR	serial a/b:d, shutting down	Shutdown command
FR	serial a/b:d, station up, DLCI nnn
FR	serial a/b:d, unknown LMI message	Cannot decode the received LMI Message.
FR	Serial a/b:d, dlci nn, No InVArp response	The remote peer is not responding to Inverse ARP requests.
	from remote
FR	Max. packet size based on CIR,BC,BE is
	less than 1514 bytes

Refer to the table below for all Low severity alarms and events reported by the XSR. All of the following messages are USER_LEVEL facility except for those in bold text which are

SECURITY_LEVEL.

Table A-8 Low Severity Alarms/Events

Module	Message	Description
T1E1	Receiver has Loss of Signal (Red Alarm).	Indicates that T1/E1 physical port is detecting LOS Alarm.
T1E1	LOS alarm on receiver cleared.	Indicates that T1/E1 physical port is not detecting LOS Alarm.

XSR User’s Guide A-11