Juniper Networks SSG 20 manual Activate wireless changes

SSG 20 Hardware Installation and Configuration Guide

5. Activate wireless changes.

Wireless > General Settings > Click Activate Changes.

CLI

1.Set the WLAN country code and IP address.

set wlan country-code {code_id}

set interface wireless_interface ip ip_addr/netmask

2.Set the SSID.

set ssid name name_str

set ssid name_str authentication auth_type encryption encryption_type set ssid name_str interface interface

(optional) set ssid name_str key-id number

3.Set the WLAN mode.

set interface wireless_interface wlan both

4.Activate wireless changes.

save

exec wlan reactivate

You can set an SSID to operate in the same subnet as the wired subnet. This action allows clients to work in either interface without having to reconnect in another subnet.

To set an Ethernet and a wireless interface to the same bridge-group interface, use the WebUI or CLI as follows:

WebUI

Network > Interfaces > List > Edit (bgroup_name) > Bind Port: Select the wireless and ethernet interfaces, then click Apply.

CLI

set interface bgroup_name port wireless_interface set interface bgroup_name port ethernet_interface

NOTE: Bgroup_name can be bgroup0—bgroup3.

Ethernet_interface can be ethernet0/0—ethernet0/4.

Wireless_interface can be wireless0/0—wireless0/3.

If a wireless interface is configured, then you need to reactivate the WLAN with the exec wlan reactivate CLI command or click Activate Changes on the Wireless > General Settings WebUI page.

40„ Basic Wireless Configuration