Juniper Networks SSG 20 manual Fields in Isdn Physical Layer Tab Window Description, SPID1, SPID2

SSG 20 Hardware Installation and Configuration Guide

Table 21: Fields in ISDN Physical Layer Tab Window

Field	Description
Switch Type	Sets the service provider switch type:
	„ att5e: At&T 5ESS
	„ ntdms100: Nortel DMS 100
	„ ins-net: NTT INS-Net
	„ etsi: European variants
	„ ni1: National ISDN-1
SPID1	Service Provider ID, usually a seven-digit telephone number with
	some optional numbers. Only the DMS-100 and NI1 switch
	types require SPIDs. The DMS-100 switch type has two SPIDs
	assigned, one for each B-channel.
SPID2	Backup service provider ID.
TEI Negotiation	Specifies when to negotiate TEI, either at startup or on the first
	call. Typically this setting is used for ISDN service offerings in
	Europe and connections to DMS-100 switches that are designed
	to initiate TEI negotiation.
Calling Number	ISDN network billing number.
Sending Complete checkbox	Enables sending of complete information to outgoing setup
	message. Usually only used in Hong Kong and Taiwan.

You can select the bri1/0 interface to connect using dialer, multi-link dialer, leased line, or dial with BRI. Selecting neither, one, or both options displays a window similar to the following.

76„