Juniper Networks 5000 SERIES manual Servicing the Device

Table of Contents

	Performing Initial Connection and Configuration	25
	Establishing a Terminal Emulator Connection	25
	Upgrading the Firmware During the Boot Process	26
	Changing Your Admin Name and Password	27
	Setting Port and Interface IP Addresses	27
	Viewing Current Interface Settings	27
	Setting the IP Address of the Management Interface	27
	Setting the IP Address for the Trust Zone Interface	28
	Setting the IP Address for the Untrust Zone Interface	28
	Allowing Outbound Traffic	29
	Configuring the Device for Telnet and WebUI Sessions	29
	Starting a Console Session Using Telnet	29
	Starting a Console Session Using Dialup	30
	Establishing a GUI Management Session	30
	Configuring the Chassis Alarm	31
	Configuring Aggregate Interfaces	32
	Using CLI Commands to Reset the Device	33
Chapter 4 Servicing the Device		35
	Removing and Reseating Modules	36
	Replacing a DC Power Supply	36
	Replacing an AC Power Supply	37
	Replacing the Fan Tray	37
	Connecting and Disconnecting Gigabit Ethernet Cables	38
	Removing and Installing a Mini-GBIC Transceiver	39
Appendix A	Specifications	41
	NetScreen-5200 Attributes	42
	NetScreen-5400 Attributes	42
	Electrical Specification	42
	Environmental Specification	42
	NEBS Certifications	43
	Safety Certifications	43
	EMI Certifications	43
	Connectors	43
Appendix B	Port Descriptions and LED Status	45
	Module Port Descriptions	46
	Module LED Descriptions	47

vi User’s Guide