Juniper Networks 5000 SERIES manual Using CLI Commands to Reset the Device

Using CLI Commands to Reset the Device

Notice that the listing contains aggregate1, an aggregate interface comprised of ethernet2/1 and ethernet2/2. This aggregate interface runs with a throughput rate of 2 Gbps. You can now bind the aggregate interface to a zone.

Note: As with most other interfaces, you must assign the aggregate interface an IP address so that other nodes on the network can reach it.

USING CLI COMMANDS TO RESET THE DEVICE

If you lose the admin password, you can use the following procedure to reset the NetScreen-5000 Series device to its default settings. This destroys any existing configurations, but restores access to the device.

Warning: Resetting the NetScreen-5000 Series will delete all existing configuration settings, and the firewall and VPN services will be rendered inoperative.

To perform this operation, you need to make a console connection, as described in “Establishing a Terminal Emulator Connection” on page 25.

Note: By default the device recovery feature is enabled. You can disable it by entering the

following CLI command: unset admin device-reset.

1.At the login prompt, type the serial number of the NetScreen-5000 Series device.

2.At the password prompt, type the serial number again. The following message appears:

!!! Lost Password Reset !!! You have initiated a command to reset the device to factory defaults, clearing all current configuration, keys and settings. Would you like to continue? y/[n]

NetScreen-5000 Series 33