Hawking Technology H2BR4 manual Wan

Page 31

Parameters

Description

Host Address

This is the IP address of the host on the Internet that will have management/configuration access

 

to the Broadband router from a remote site. This means if you are at home and your home IP

 

address has been designated the Remote Management host IP address for this router (located in

 

your company office), then you are able to configure this router from your home. If the Host

 

Address is left 0.0.0.0 this means anyone can access the router’s web-based configuration from a

 

remote location, provided that they know the password.

 

Click the Enabled box to enable the Remote Management function.

 

Note: When you want to access the web-based management from a remote site, you must enter

 

the router’s WAN IP address (e.g. 10.0.0.1) into your web-browser followed by port number

 

8080, e.g. 10.0.0.1:8080 (see below). You’ll also need to know the password set in the Password

 

Setting screen in order to access the router’s web-based management.

Click Apply at the bottom of the screen to save the above configurations. You can now configure other advanced sections or start using the router (with the advanced settings in place).

2.2 WAN

Use the WAN Settings screen if you have already configured the router via the Quick Setup Wizard section and you would like to change your Internet connection type. The WAN Settings screen allows you to specify the type of WAN port connection you want to establish with your ISP. In the WAN Settings screen, you can also configure the router to act as a bridge. The WAN settings offer the following selections for the router’s WAN port: Dynamic IP, Static IP, PPPoE, PPTP, L2TP, Telstra Big Pond, Policy, DNS and DDNS. You will need to select one of the two WAN ports first and configure one WAN port at a time.

31

Image 31
Contents Page Hawking Limited Warranty Page Page Page Features Get to Know the Broadband Router Minimum RequirementsBack Panel Front Panel Local Area Network LANConfigure your PC to obtain an IP address automatically Setup DiagramGetting started 2a Windows 95/98/Me DNS Configuration Select Disable DNS2b Windows 2c Windows NT IP Address Select Obtain an IP address from a Dhcp server Page Status Information Chapter Functions to meet your LAN requirements Page Set Time Zone About Quick SetupEnable Daylight Savings Time ZoneBroadband Type Pptp Cable ModemFixed-IP xDSL PPPoEExplanation on MAC addresses DNS MTU Pptp BEZEQ-ISRAEL General Settings System WANTime Zone System SettingsPassword Settings Remote Management For VerificationWAN Telstra Big Pond Dynamic IP addressStatic IP address 5 L2TPPptp Dynamic IP AddressStatic IP Address PPPoE PPP over EthernetPage MTU Telstra Big Pond WAN Policy 8 DNS Ddns Page LAN IP Address Pool IP addressNAT Port Forwarding Page Virtual Server Example Virtual Server Special Applications Page Example Example Special ApplicationsUPnP Protocol and Port Binding Page ALG Settings Static Routing Firewall Page Access Control Page Add PC Example Access Control URL Blocking DoS Denial of Service Intrusion Detection Features 4 DMZ Page Status Status and Information Internet Connection Device Status View the operation log of the system System LogSecurity Log Active Dhcp Client Statistics Tools Configuration Tools Firmware Upgrade Reset Type Ipconfig /all and click Enter How to Manually Find Your PC’s IP and MAC AddressesPage TCP FTP Smtp POP3