GarrettCom Magnum 6KQ manual Connecting Ethernet Media, Connecting Fiber Optic ST-type, twist-lock

Page 26

Magnum 6KQ Managed Field Switch Installation and User Guide

(04/07)

For DC power input data, see Appendix B. For Dual Source, see Appendix C

.

The rugged metal case of the Magnum 6KQ will normally protect it from accidental damage in a lab or workplace setting. Maintain an open view of the front to visually monitor the status LEDs. Keep an open area around the unit so that cooling can occur from convection while the unit is in operation. The 6KQ has no fans, so it is silent when in operation. Internal electronics use the case as a heat sink, so the unit may normally be quite warm to the touch.

3.2Connecting Ethernet Media

The Magnum 6KQ Switches are specifically designed to support all standard

Ethernet media types within a single Switch unit. This is accomplished by using a family of different Port Modules which can be individually selected and configured per-slot. See Section 2.2 for a description of the PMs.

The various media types supported along with the corresponding IEEE 802.3, 802.3D, 802.3u, 802.3AB and 802.3z standards and connector types are as follows:

IEEE Standard	Media Type	Max. Distance
Fiber:	mm1 Fiber
100BASE-FX	mm1 Fiber	220m ( ft)
	sgl.m2 Fiber	5Km
100BASE-FX	mm1 Fiber	2.0km (6,562 ft)
	sgl.m2 Fiber	18.0km (95K ft)
small form factor	mm1 Fiber	2.0km (6,562 ft)
small form factor	sgl.m1 Fiber	15 km
Copper:
10BASE-T and 100BASE-TX twisted pair100m (328 ft)
1000BASE-TX twisted pair		100m (328 ft)

Port Module

GBIC-SXSC

GBIC-LXSC

6K4-MSC, -MST SSC, SSCL 6KQ-MTRJ, -MLC 6KP4V- SLC

6KQ-RJ45

GBIC-TP

1 mm = multi-mode

2 sgl.m = single-mode

3.2.1Connecting Fiber Optic ST-type, “twist-lock”

The following procedure applies to installations using a PM with ST-type fiber connectors. This procedure applies to ports using a 6KQ module, MST-type port.

1.Before connecting the fiber optic cable, remove the protective dust caps from the tips of the connectors on the PM. Save these dust caps for future use.

www. GarrettCom . com

20

Image 26

Contents Managed Field Switch Trademarks Contacting GarrettCom, Inc Canadian EmissionIntroduction Magnum 6KQ Managed Field Switch Port Modules35 Table of ContentsInstallation IntroductionTroubleshooting Magnum Line OverviewNetwork Standards and Compliance, hardware Technical SpecificationsPerformance Maximum 10 Mbps Ethernet Segment LengthsAlarm Relay Contacts Fiber Multi-mode connector types supportedFiber Single-mode connector types Management Console connectorAgency Approvals and Standards Compliance DC-DUAL Power Source Optional6KQ Mounting Ordering Information Www . GarrettCom . com Introduction Inspecting the Package and Product Product Description Magnum 6KQ Field Switch Www . GarrettCom . com SFF Fiber Port Modules 6KQ4-MTRJ F/Habove 6KQ4MLC or -SLC belowFour-Port Copper Module, 6KQ4-RJ45 Two-Port Fiber Modules, 2@ 100Mb fiber @ 10/100/1000Mb RJ-45 + 1@ 1000Mb SFP Two -Port 10 Mb mm Fiber ST ModulesSFP Gigabit 1000Mbps port modules Packet Prioritization, 802.1p QOS Frame Buffering and Flow ControlManaged Network Software MNS-6K for Magnum 6KQ-Series Web-browser, at ftp//ftp.garrettcom.com„ Features Fiber-Built-In Features and Benefits„ Managed switching for high performance Ethernet LANs Example 1 Magnum 6KQ Switch for a Industrial Application Applications4a- The industrial factory floor application with Magnum 6KQ Snmp Locating Magnum 6KQ Switches Ieee Standard Media Type Max. Distance Fiber Connecting Ethernet MediaConnecting Fiber Optic ST-type, twist-lock CopperConnecting Twisted Pair CAT3, CAT5, Unshielded or Shielded Connecting Fiber Optic SC-type, Snap-InConnecting Single-Mode Fiber Optic Media Ieee StandardWww . GarrettCom . com Side View Duplex LC connector Front view Gigabit SFP Small Form-factor Pluggable Optical Transceivers6a Connecting Fiber Optic Cable to SFP Transceivers DIN-Rail Mounting the Magnum 6KQ Mounting Dimensions for 6KQ with metal brackets Powering the Magnum 6KQ Managed Field Switch Relay Contacts Male Connector 6KQ Port Module 6KPM InstallationFemale Connector Pin Name Description Dir Switching Functionality Filtering and ForwardingPWR Status LEDsAuto-CrossMDIX and Auto-negotiation, for RJ-45 ports ACTThis manual to access the 6K-MNSRel 3 Software user guide Power Budget Calculations for 6KQ PM’s with Fiber Media Flow-control, Ieee 802.3x standardF10ST MLCIntroduction Magnum 6KQ Managed Field Switch Port Modules 6KPM Module Description1a 6KQ2-10ST, 2@10Mb multi-mode FX-ST twist lock Module KQF-2MSC, 2@100Mb multi-mode FX-SC snap-in Fiber connector FX-SC-type, snap-in 5 6KQ4-MT, 4 @100Mb multi-mode FX , Mtrj Small-Form-factor7 6KQ4-MLC, 4 ports @ 100Mbps multi-mode LC connector SFF @ 10/100Mbps RJ-45 @100Mb multi-mode FX , Mtrj Small-FFMbps RJ-45 Connector 9 6KQ4-RJ45 Twisted Pair, 10/100Mb, 4-PortPoE LEDs Summary SFPs, Gigabit 1000Mbps port modules 12 6KQ-BLNK Before Calling for AssistanceNo Problem Found When Calling for AssistanceReturn Material Authorization RMA Procedure Shipping and Packaging InformationAppendix a Warranty Information B3.0 Applications for DC Powered Ethernet Switches Standard 6KQ DC Power Input Terminal Block -, GND, +B2.0 -48VDC, 24VDC and 125VDC POWER, Theory of Operation B4.0 6KQ, -48V, 24, 125VDC Installation B4.1 UL Requirements for DC-powered unitsB6.0 Troubleshooting B5.0 OperationC4.0 Features and Benefits of the DUAL-SOURCE Design C5.0 InstallationC6.0 Ordering Information Or Dual-Src125V-SwitchC5.1 UL Requirements Example Magnum 6KQ-24VDC or Magnum P6KQ-125VDC