Magnum 6KQ Managed Field Switch Installation and User Guide | (04/07) |
to the other ports where it is not needed. Traffic needed for maintaining the un- interrupted operation of the network (such as occasional multi-cast packets) is forwarded to all ports.
The Magnum 6KQ Switches operate in the store-and-forward switching mode, which eliminates bad packets and enables peak performance to be achieved when there is heavy traffic on the network.
Address Learning
All Magnum 6KQ units have address table capacities of 4K node addresses suitable for use in larger networks. They are self-learning, so as nodes are added, removed or moved from one segment to another, the 6KQ Switch automatically keeps up with node locations.
An address-aging algorithm causes least-used addresses to fall out in favor for frequently-used addresses. To reset the address buffer, cycle power down-and-up.
4.2Status LEDs
For Magnum 6KQ models (/6KQ) :
PWR | : Power LED, ON when external power is applied to the unit. |
LK | : Steady ON, Link status for 10 Mbps and 100Mbps operation. |
ACT | : ON with port activity for 10 Mbps and 100Mbps operation. |
F/H | : Full / Half duplex LED, ON when the port is running full duplex, |
| OFF for half duplex. |
100/10 | : Speed LED, ON when the speed is 100Mbps , OFF when the |
| speed is 10 Mbps |
4.3Auto-Cross(MDIX) and Auto-negotiation, for RJ-45 ports
The RJ-45 ports independently support auto-cross (MDI or MDIX) in auto-negotiation mode and will work properly with all the other connected devices with RJ-45 ports whether they support Auto-negotiation (e.g 10Mb Hub, media converter) or fixed mode at 10Mb or 100Mb Half/Full Duplex(managed switch) or not. No cross-over cable is required while using the 6KQ’s copper port to other devices. Operation is according to the IEEE 802.3u standard.
The Managed 6KQ’s Fast Ethernet copper ports can be set for either fixed 100Mb speed or for 10/100 F/H N-way auto-negotiation per the IEEE802.3u standard. The selection is made via MNS software. The factory default setting is for auto-negotiation. At 10Mb or 100Mb-fixed speed, the user may select half- or full-duplex mode by MNS Software for each RJ-45 port separately. For detail information See Section (2.2.9 at page no.14) of
www . GarrettCom . com
31
