GarrettCom Introduction Magnum 6KQ Managed Field Switch Port Modules, 6KPM Module Description

Page 41

Magnum 6KQ Managed Field Switch Installation and User Guide

(04/07)

The 100Mb fiber segment must operate in full-duplex (FDX) mode, i.e. the full-duplex (factory default) setting for 100Mbps fiber ports must be used, and

The worst-case OPB of the fiber link must be greater than the fiber cable’s passive Attenuation.

(Attenuation = Cable loss + LED aging loss + Insertion loss + safety factor)

5.0Introduction - Magnum 6KQ Managed Field Switch Port Modules

This chapter describes each Port Module (PM), including appearance, functionality, and status displays.

5.1Inspecting the Package and Product

This section applies only to PMs shipped as separate items, i.e., 6KQ PMs not factory installed in a Magnum 6KQ PM slot.

Examine the shipping container for obvious damage prior to installing a 6KQ PM; notify the carrier of any damage you believe occurred during shipment or delivery. Inspect the contents of this package for any signs of damage and ensure that the items listed below are included.

This package should contain:

1 or more 6KQ units ( or 6KQ) PMs

Installation instructions, with illustrations

Remove the 6KQ PM(s) from the shipping container. Be sure to keep the shipping container should you need to ship any of the PMs separately at a later date. In the event there are items missing or damaged, contact your supplier. If you need to return the unit, use the original shipping container if possible. Refer to Chapter 5 for specific return procedures.

5.26KPM Module Description

An important feature of the Magnum 6KQ is the use of Port Modules for flexible mixed-media connectivity to RJ-45 and fiber media. Since the Magnum 6KQ Switches have dual-speed capability for copper ports, the 1, 2, 3, or 4-port interfaces are designed to support all standard Ethernet media types at 10 or 100 or 1000Mps speed. Each 6KQ PM provides a wide selection of connecting Ethernet media segments with all similar or combo connector types.

www . GarrettCom . com

35

Image 41
Contents Managed Field Switch Trademarks Canadian Emission Contacting GarrettCom, IncInstallation Table of ContentsIntroduction Magnum 6KQ Managed Field Switch Port Modules35 IntroductionTroubleshooting Overview Magnum LinePerformance Technical SpecificationsNetwork Standards and Compliance, hardware Maximum 10 Mbps Ethernet Segment LengthsFiber Single-mode connector types Fiber Multi-mode connector types supportedAlarm Relay Contacts Management Console connectorAgency Approvals and Standards Compliance DC-DUAL Power Source Optional6KQ Mounting Ordering Information Www . GarrettCom . com Introduction Inspecting the Package and Product Product Description Magnum 6KQ Field Switch Www . GarrettCom . com 6KQ4-MTRJ F/Habove 6KQ4MLC or -SLC below SFF Fiber Port ModulesFour-Port Copper Module, 6KQ4-RJ45 Two-Port Fiber Modules, 2@ 100Mb fiber @ 10/100/1000Mb RJ-45 + 1@ 1000Mb SFP Two -Port 10 Mb mm Fiber ST ModulesSFP Gigabit 1000Mbps port modules Frame Buffering and Flow Control Packet Prioritization, 802.1p QOSWeb-browser, at ftp//ftp.garrettcom.com Managed Network Software MNS-6K for Magnum 6KQ-Series„ Features Fiber-Built-In Features and Benefits„ Managed switching for high performance Ethernet LANs Applications Example 1 Magnum 6KQ Switch for a Industrial Application4a- The industrial factory floor application with Magnum 6KQ Snmp Locating Magnum 6KQ Switches Connecting Fiber Optic ST-type, twist-lock Connecting Ethernet MediaIeee Standard Media Type Max. Distance Fiber CopperConnecting Single-Mode Fiber Optic Connecting Fiber Optic SC-type, Snap-InConnecting Twisted Pair CAT3, CAT5, Unshielded or Shielded Media Ieee StandardWww . GarrettCom . com Gigabit SFP Small Form-factor Pluggable Optical Transceivers Side View Duplex LC connector Front view6a Connecting Fiber Optic Cable to SFP Transceivers DIN-Rail Mounting the Magnum 6KQ Mounting Dimensions for 6KQ with metal brackets Powering the Magnum 6KQ Managed Field Switch Relay Contacts Male Connector 6KQ Port Module 6KPM InstallationFemale Connector Pin Name Description Dir Filtering and Forwarding Switching FunctionalityAuto-CrossMDIX and Auto-negotiation, for RJ-45 ports Status LEDsPWR ACTThis manual to access the 6K-MNSRel 3 Software user guide Flow-control, Ieee 802.3x standard Power Budget Calculations for 6KQ PM’s with Fiber MediaMLC F10ST6KPM Module Description Introduction Magnum 6KQ Managed Field Switch Port Modules1a 6KQ2-10ST, 2@10Mb multi-mode FX-ST twist lock Module KQF-2MSC, 2@100Mb multi-mode FX-SC snap-in Fiber connector 5 6KQ4-MT, 4 @100Mb multi-mode FX , Mtrj Small-Form-factor FX-SC-type, snap-in@ 10/100Mbps RJ-45 @100Mb multi-mode FX , Mtrj Small-FF 7 6KQ4-MLC, 4 ports @ 100Mbps multi-mode LC connector SFF9 6KQ4-RJ45 Twisted Pair, 10/100Mb, 4-Port Mbps RJ-45 ConnectorPoE LEDs Summary SFPs, Gigabit 1000Mbps port modules Before Calling for Assistance 12 6KQ-BLNKReturn Material Authorization RMA Procedure When Calling for AssistanceNo Problem Found Shipping and Packaging InformationAppendix a Warranty Information B3.0 Applications for DC Powered Ethernet Switches Standard 6KQ DC Power Input Terminal Block -, GND, +B2.0 -48VDC, 24VDC and 125VDC POWER, Theory of Operation B4.1 UL Requirements for DC-powered units B4.0 6KQ, -48V, 24, 125VDC InstallationB5.0 Operation B6.0 TroubleshootingC5.0 Installation C4.0 Features and Benefits of the DUAL-SOURCE DesignC5.1 UL Requirements Or Dual-Src125V-SwitchC6.0 Ordering Information Example Magnum 6KQ-24VDC or Magnum P6KQ-125VDC