GarrettCom 6K25e manual 14 6KM-BLNK, Before Calling for Assistance

Page 61

Magnum 6K25e Gigabit Fiber Switch

Installation and User Guide (10/07)

Each port has an Activity (ACT) LED indicating packets being received and a link (LK) LED indicating proper connectivity with the remote device when lit.

5.2.146KM-BLNK

The 6KM-BLNK is a blank face plate or cover plate that must be installed in

any empty 6K25e PM slot to maintain proper cooling air flow, safety, etc.

Two screws underneath the front panel hold the 6KM-BLNK in place.

6.0TROUBLESHOOTING

All Magnum Ethernet products are designed to provide reliability and consistently high performance in all network environments. The installation of a Magnum 6K25e Switch is a straightforward procedure (see INSTALLATION, Section 2.6); the operation is also straightforward and is discussed in Section 4.

Should problems develop during installation or operation, this section is intended to help locate, identify and correct these types of problems. Please follow the suggestions listed below prior to contacting your supplier. However, if you are unsure of the procedures described in this section or if the Magnum 6K25e Switch is not performing as expected, do not attempt to repair the unit; instead contact your supplier for assistance or contact GarrettCom Customer Support.

6.1Before Calling for Assistance

1.If difficulty is encountered when installing or operating the unit, refer back to the Installation Section of the applicable chapter of this manual. Also check to make sure that the various components of the network are interoperable.

2.Check the cables and connectors to ensure that they have been properly connected and the cables/wires have not been crimped or in some way impaired during installation. (About 90% of network downtime can be attributed to wiring and connector problems.)

3.Make sure that an AC power cord is properly attached to each Magnum 6K25e Switch unit. Be certain that each AC power cord is plugged into a functioning electrical outlet. Use the PWR LEDs to verify each unit is receiving power.

www . GarrettCom . com

55

Image 61
Contents Gigabit Fiber Switch Trademarks Canadian Emission Contacting GarrettCom, IncIntroduction Table of ContentsRevisions 6K25E Managed Fiber Switch Port ModulesMagnum Line Performance Technical SpecificationsNetwork Standards and Compliance, hardware Maximum 10 Mbps Ethernet Segment LengthsFiber Single-mode connector types Fiber Multi-mode connector types supportedManagement Console connector Power Supply InternalNebs Testing and Certification Nebs certified Alarm Contact OptionalPer-port MDI or Mdix on RJ-45 Agency ApprovalsOrdering Information 6K PoE Modules with 48VDC Pass-Through For Gigabit module configuration options6K PoE Modules with 48VDC Power Inside Introduction Inspecting the Package and Product Product Description Magnum 6K25e Managed Fiber SwitchWww . GarrettCom . com Eight-port SFF fiber modules 6K8-MTRJ, 6K8-MLC, 100Mb fiber Magnum 6K25e and 6K25eR chassisPort modules for the Magnum 100Mb fiber eightEight-Port Copper Module, 6K8-RJ45 The 6K25e-Series’s8-port New PoEPower Inside, model PI6KP8-45RJ MDIX, 10/100Mb 8-port Per the IEEE802.3af PoE Four-Port 10 Mb mm Fiber ST Modules Gigabit 1000Mbps port modules Frame Buffering and Flow Control Packet Prioritization, 802.1p QOSWeb-browser, at ftp//ftp.garrettcom.com Managed Network Software MNS-6K for Magnum 6K25e-Series„ Features Fiber-Built-In „ Managed switching for high performance Ethernet LANs„ Nebs and Etsi tested and certified „ SFP Gigabit module being supported on Slot D „ RJ-45 ports are MDI/MDIX supportedApplications 6K 25e Locating Magnum 6K25e Switches InstallationConnecting Fiber Optic ST-type, twist-lock Connecting Ethernet MediaIeee Standard Media Type Max. Distance Port Module Fiber CopperConnecting Single-Mode Fiber Optic Connecting Fiber Optic SC-type, Snap-InMedia Ieee Standard Media Ieee Standard Gigabit SFP Small Form-factor Pluggable Optical Transceivers Side View Duplex LC connector Front viewSFP-SX SFP-LX10 SFP-LX25 SFP-ZX40 SFP-ZX70 Table-Top or Shelf Mounting1 Mountings for Magnum 6K25e units rack-mounted in a frame Rack-mounting for 19 Retma racks, regular Magnum 6K25esRack-mounting, Reverse version of the Magnum 6K25es Powering the Magnum Managed Fiber SwitchWww . GarrettCom . com Preparation for Installing and Removing 6KPMs 6K25e Port Module 6KPM InstallationRemove Chassis Cover 1a Removing Chassis Cover Installing 6KPM Cards in the Magnum 6K25e Uplink 2f Securely latching up 6KPM Cards into a Magnum 6K25e Removing 6KPM Cards Console DB-9 Port Connecting the Console Terminal to Magnum 6K25e ManagementRemove 6KPM Card Switching Functionality Pin Signal DescriptionDB-9 Console port connector 1 RS-232 DB-9 Console Com port Serial port pin assignmentsUp-link MDI-MDIX on RJ-45 port modules, for port 1 only Status LEDsPWR ACTAuto-CrossMDIX and Auto-negotiation, for RJ-45 ports Flow-control, Ieee 802.3x standard F10ST Introduction Magnum 6K25e Managed Fiber Switch Port Modules 6KPM Module Description 1b 6KP4-F10ST, 4@10Mb multi-mode FX-ST twist lock Module @10Mb @100Mb Multi-mode FX-ST twist 1c 6KP4Lock Module Mode SC-type connectors. It Provides an advantage Mode 100Mbps fiber opticFiber functions in one Module of the 6K25e Switch Transceivers all in one module. ThisWww . GarrettCom . com Activity FULL/HALF Port@ 100Mbps Multi-Mode Fiber portLink Form Factor 9 6KP8-RJ45 Twisted Pair, 10/100Mb 8-Port Option in one 6K-unit Fig. the top 8-RJ45 PoE LEDs Summary10/100 GBIC-SXSC Gigabit fiber1000Mb, multi-mode SC Connector Before Calling for Assistance 14 6KM-BLNKReturn Material Authorization RMA Procedure When Calling for AssistanceShipping and Packaging Information No Problem FoundSpecifications for Magnum 6K25E SWITCHES, DC Power Appendix B Internal DC Power Supply OptionsB3.0 Applications for DC Powered Switches Magnum 6K25es. see figure at right B4.0 InstallationB4.1 UL Requirements for DC-powered units Appendix C Internal DC Dual-Source Power OptionB7.0 Troubleshooting B5.0 OperationC5.0 Installation C4.0 Features and Benefits of the DUAL-SOURCE DesignC6.0 Ordering Information C5.1 UL RequirementsExample Magnum 6K25eR-48VDC Example Magnum 6K25eR-24VDC or Magnum 6K25eR-125VDCOperation C7.0