GarrettCom manual Rack-mounting, Reverse version of the Magnum 6K25es

Page 34

Magnum 6K25e Gigabit Fiber Switch

Installation and User Guide (10/07)

package, along with the necessary screws for attaching the brackets to the sides of the Magnum Switch unit. They must be ordered as line items.

3.3.2 Rack-mounting, Reverse version of the Magnum 6K25es

The optional Reverse Magnum 6K25e Model has all of the cabling (Ethernet cabling, power cabling and console port cabling) connectors in the rear, and the status LEDs in the front. The status LEDs that are co-incident with the ports are still present there, and a second or dual set of LEDs are used for status visibility in the front of the unit, showing the same data.

There are three options of brackets available to mount in the standard 19” frame or the 23” frame or ETSI (21”) frame. The 19” brackets are included with each unit, the other two may be purchased if desired.

 

 

With each bracket type, there are three different mounting options is shown in

Fig. 3.3.2. The case of the Magnum 6K25e has mounting holes prepared for each of the

mounting arrangements. Users may choose the mounting arrangement most suitable for

 

 

 

 

 

 

their

 

 

 

 

 

 

installation

D

D C

C B

B A

A

Standard Flush

.

 

 

 

 

 

Mount Bracket

 

 

 

 

 

 

 

Fig

 

 

 

 

 

Mid-Range Mount or

3.3.2

D

D C

C B

B A

A

5” Set-Back Bracket

Reverse

 

 

 

 

 

 

 

 

 

 

 

Magnum

 

 

 

 

 

 

6K25e

 

 

 

 

 

 

units,

 

 

 

 

 

Rear Mount Bracket

rack-

D

D C

C B

B A

A

 

mounted

 

 

 

 

 

 

in a frame

3.4

Powering the Magnum Managed Fiber Switch

The Magnum 6K25e Switches incorporate an internal universal power supply and have a recessed male IEC connector for the AC power cord at the left-rear. A manual power ON-OFF switch is adjacent. A six-foot 115 VAC 60 Hz standard power cord is supplied with each unit shipped within the United States and Canada.

The auto-ranging power supply supports installation environments where the AC voltage is from 90 to 260 volts with a power input frequency between 47 and 63 Hz. The 25-port units will consume over 20 watts of power typically. When connecting the

www . GarrettCom . com

28

Image 34
Contents Gigabit Fiber Switch Trademarks Contacting GarrettCom, Inc Canadian EmissionTable of Contents Introduction6K25E Managed Fiber Switch Port Modules RevisionsMagnum Line Network Standards and Compliance, hardware Technical SpecificationsPerformance Maximum 10 Mbps Ethernet Segment LengthsManagement Console connector Fiber Multi-mode connector types supportedFiber Single-mode connector types Power Supply InternalPer-port MDI or Mdix on RJ-45 Alarm Contact OptionalNebs Testing and Certification Nebs certified Agency ApprovalsOrdering Information For Gigabit module configuration options 6K PoE Modules with 48VDC Pass-Through6K PoE Modules with 48VDC Power Inside Product Description Magnum 6K25e Managed Fiber Switch Introduction Inspecting the Package and ProductWww . GarrettCom . com Magnum 6K25e and 6K25eR chassis Eight-port SFF fiber modules 6K8-MTRJ, 6K8-MLC, 100Mb fiberPort modules for the Magnum 100Mb fiber eightEight-Port Copper Module, 6K8-RJ45 The 6K25e-Series’s8-port New PoEPower Inside, model PI6KP8-45RJ MDIX, 10/100Mb 8-port Per the IEEE802.3af PoE Four-Port 10 Mb mm Fiber ST Modules Gigabit 1000Mbps port modules Packet Prioritization, 802.1p QOS Frame Buffering and Flow ControlManaged Network Software MNS-6K for Magnum 6K25e-Series Web-browser, at ftp//ftp.garrettcom.com„ Features Fiber-Built-In „ Managed switching for high performance Ethernet LANs„ Nebs and Etsi tested and certified „ RJ-45 ports are MDI/MDIX supported „ SFP Gigabit module being supported on Slot DApplications 6K 25e Installation Locating Magnum 6K25e SwitchesIeee Standard Media Type Max. Distance Port Module Fiber Connecting Ethernet MediaConnecting Fiber Optic ST-type, twist-lock CopperConnecting Single-Mode Fiber Optic Connecting Fiber Optic SC-type, Snap-InMedia Ieee Standard Media Ieee Standard Side View Duplex LC connector Front view Gigabit SFP Small Form-factor Pluggable Optical TransceiversTable-Top or Shelf Mounting SFP-SX SFP-LX10 SFP-LX25 SFP-ZX40 SFP-ZX70Rack-mounting for 19 Retma racks, regular Magnum 6K25es 1 Mountings for Magnum 6K25e units rack-mounted in a framePowering the Magnum Managed Fiber Switch Rack-mounting, Reverse version of the Magnum 6K25esWww . GarrettCom . com Preparation for Installing and Removing 6KPMs 6K25e Port Module 6KPM InstallationRemove Chassis Cover 1a Removing Chassis Cover Installing 6KPM Cards in the Magnum 6K25e Uplink 2f Securely latching up 6KPM Cards into a Magnum 6K25e Removing 6KPM Cards Console DB-9 Port Connecting the Console Terminal to Magnum 6K25e ManagementRemove 6KPM Card DB-9 Console port connector Pin Signal DescriptionSwitching Functionality 1 RS-232 DB-9 Console Com port Serial port pin assignmentsPWR Status LEDsUp-link MDI-MDIX on RJ-45 port modules, for port 1 only ACTAuto-CrossMDIX and Auto-negotiation, for RJ-45 ports Flow-control, Ieee 802.3x standard F10ST Introduction Magnum 6K25e Managed Fiber Switch Port Modules 6KPM Module Description 1b 6KP4-F10ST, 4@10Mb multi-mode FX-ST twist lock Module @10Mb @100Mb Multi-mode FX-ST twist 1c 6KP4Lock Module Fiber functions in one Module of the 6K25e Switch Mode 100Mbps fiber opticMode SC-type connectors. It Provides an advantage Transceivers all in one module. ThisWww . GarrettCom . com Activity FULL/HALF Port@ 100Mbps Multi-Mode Fiber portLink Form Factor 9 6KP8-RJ45 Twisted Pair, 10/100Mb 8-Port Option in one 6K-unit PoE LEDs Summary Fig. the top 8-RJ4510/100 GBIC-SXSC Gigabit fiber1000Mb, multi-mode SC Connector 14 6KM-BLNK Before Calling for AssistanceWhen Calling for Assistance Return Material Authorization RMA ProcedureNo Problem Found Shipping and Packaging InformationSpecifications for Magnum 6K25E SWITCHES, DC Power Appendix B Internal DC Power Supply OptionsB3.0 Applications for DC Powered Switches B4.0 Installation Magnum 6K25es. see figure at rightB7.0 Troubleshooting Appendix C Internal DC Dual-Source Power OptionB4.1 UL Requirements for DC-powered units B5.0 OperationC4.0 Features and Benefits of the DUAL-SOURCE Design C5.0 InstallationExample Magnum 6K25eR-48VDC C5.1 UL RequirementsC6.0 Ordering Information Example Magnum 6K25eR-24VDC or Magnum 6K25eR-125VDCC7.0 Operation