GE P485 instruction manual Mechanical installation, Indicators and switches

Page 15

INSTALLATION

Mechanical installation

DIN-RAIL MOUNTING The DIN-rail connector is internally connected to the P485.

	1
ON	OFF

1

2		2

Figure 2-8: Mounting the P485 to the DIN-rail

To snap the P485 on, first press the P485 downwards (1) to compress the spring on the DIN- rail connector, then push the P485 against the DIN-rail as to make it snap on (2)

To snap the P485 off, push the P485 downwards (1) and pull it out from the DIN-rail (2), as to make it snap off from the DIN-rail.

Indicators and switches

STATUS INDICATORS The status indicators for the P485 Modbus to Profibus Converter are indicated below.

1 2

3 4

5 6

Figure 2-9: P485 status indicators

P485 MODBUS TO PROFIBUS CONVERTER – USER GUIDE

2–5

Image 15

Contents GE Multilin P485 Modbus to Profibus ConverterPage P485 Modbus to Profibus Converter Table of contentsSoftware Frame Miscellaneous Getting started IntroductionInput and output definition Document conventionsFeatures FeaturesAbout the P485 Modbus to Profibus Converter Communications SpecificationsMechanical Housing OrderingInstallation Quick installElectrical installation Pin Signal Description Profibus connector pin assignmentsPin Description Configuration cable pin assignments P485 endConfiguration cable PC end Indicators and switches Mechanical installationNumber Description State Status P485 status indicatorsInput/output bytes required Modules Profibus installation procedurePoor performance TroubleshootingOverview Data exchangeMemory Map Address Contents AccessBlocks Protocol configurationData Exchange Installation procedure Software overviewIntroduction Select Configuration Wizard and click on OK Using the EnerVista P485/D485 Setup softwareTypical network arrangement Sub-network data flow Address Command Software Overview P485 Modbus to Profibus Converter User Guide Software Overview Configurator main window Configuration main windowInformation window Function Description Fieldbus configurationP485/D485 configuration P485/D485 configurationParameter Description Range Modbus network configurationSoftware Overview PLC Communication modelP485 scan list Basic settingsMenu NodesCommunication Model P485 Modbus to Profibus Converter User Guide Communication Model Frame editor Frame and command editorsSelect command window Command editorQuery Column Select ‘Add Command’ as described earlierMain window Modbus network monitor Modbus network and node monitorsStart / Stop sub network scanning Node monitor Update OFF Update onCommand Area Control and status registers Advanced functionsCode Name Description Bits Name DescriptionHandshake bits themselves bits 14 Code Error DescriptionFieldbus control system Input/output data during startupMailbox command Advanced fieldbus configurationAdvanced Functions Overview Application exampleType Parameter Address Format Read/write For the MM2, we haveParameter User map data Address Modbus user map setupMM2 meter user map setting System configuration System configurationDB9 pin Description Setup Software Starting Configuration WizardModbus network properties Selecting the SUB-NETWORK PropertiesParameters configured for Pqmii 11 Connect devices to sub-network Connect Devices to the SUB- Network14 Select parameter window Select Parameters for Each Node17 Configuration report Queries 20 Save device file21 Expanding the tree 23 Changing configuration parameters for a query 25 Opening a saved configuration file Profibus network setup Release Dates WarrantyMiscellaneous Revision history10-2 6-3 P485 Modbus to Profibus Converter IndexPower Supply