Gefen 1080P manual System Lock Mode, Standby Mode

Page 15

MODE BUTTONS

System Lock Mode

Locking the Matrix prevents changes to any of the Matrix settings. This feature is useful in case any of the front panel buttons are pressed by accident. Locking the Matrix also prevents changes using the IR Remote Control Unit.

1Press the Lock button to activate System Lock Mode.

Press the Lock button

2 Press the Lock button a second time to deactivate System Lock Mode.

Standby Mode

1Press the Cancel button, while in any mode, to return to the Standby Mode screen.

Cancel button

Press and hold the Cancel button for 5 seconds to enable or disable Standby Mode.

12

Image 15

Contents 1080P Write To Asking for AssistanceTechnical Support Technical Support HoursContents How It Works IntroductionGefen Gefen 16x16 3GSDI Push Button MatrixOperation Notes Features FeaturesPackage Includes Front Panel Front Panel LayoutFront Panel Descriptions Mode ButtonsBack Panel Back Panel LayoutBack Panel Descriptions Reference In ConnectorConnecting 16X16 3GSDI Push Button Matrix How to Connect the 16x16 3GSDI Push Button MatrixHow to Operate the 16x16 3GSDI Push Button Matrix Operating 16X16 3GSDI Push Button Matrix Standby ScreenDisplaying Additional Information Displaying the Current Routing State Routing Sources Mode ButtonsStandby Mode System Lock ModeCycling between Information Screens Saving the current Routing State Recalling a stored Routing State Masking Outputs Communication Modes RMT-16416IR Remote Control Unit IR Remote Control DescriptionsIR Remote Control Installation Installing the RMT-16416IR BatteryBattery Slot How to Resolve IR Code Conﬂicts IR Remote Control ConfigurationIR Remote Control Key Mapping Using the IR Remote ControlRS-232 Serial Interface How do I use these features?RS-232 Serial Control RS-232 FeaturesCommand Syntax #CHECKREF Command#PRWEBADD Command #PRREFTABLE Command#SIPADD Command #RSTIP Command#SGATEWAY Command #SNETMASK Command#SPORT Command General Commands#ACTIVEBOLO Command Command #FADEFAULT Command#RMTIRADD Command Routing CommandsParam1 param2 View Matrix Status IP ControlMasking IP Conﬁguration Backup / Restore Firmware Update Firmware UpdateSystem failure System FailureRack Mount Safety Information BNC SpecificationsProduct Registration WarrantyLicensing Rev A1