IR REMOTE CONTROL CONFIGURATION
How to Resolve IR Code Conflicts
In the event that IR commands from other remote controls interfere with the supplied IR Remote Control unit, changing the IR channel on the IR Remote Control unit will fix the problem. The IR Remote Control unit has a bank of DIP switches used for setting the IR channel.
The DIP switch bank is located underneath the battery cover.
Remote Channel 0: |
|
|
|
| Remote Channel 1: |
|
|
|
|
|
|
|
|
|
| ||||
Default |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
1 | 2 |
| 1 | 2 |
| ||||
|
|
|
|
|
|
|
|
| |
Remote Channel 2: |
|
|
|
| Remote Channel 3: |
|
|
|
|
|
|
|
|
|
|
|
| ||
|
|
|
|
|
|
|
| ||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
1 | 2 |
| 1 | 2 |
| ||||
Left: Picture of the opened rear battery
compartment of the IR remote showing the
exposed DIP Switch bank between the battery chambers.
It is important that the IR channel on the Remote Control unit, matches the IR channel set on the 16x16 3GSDI Push Button Matrix. For example, if both DIP switches on the IR Remote Control unit are set to IR channel 0 (both DIP switches down), then the 16x16 3GSDI Matrix must also be set to IR channel 0. See page 28 on how to change the IR channel on the 16x16 3GSDI Push Button Matrix.
20