Gefen 1080P manual #PRREFTABLE Command, #PRWEBADD Command

Page 27

RS-232 SERIAL CONTROL

#PRREFTABLE Command

The #PRREFTABLE command displays the Ref In data table (timings) which are recognized by the 16x16 3GSDI Push Button Matrix.

Syntax:

#PRREFTABLE

Parameters:

None

				IP Conﬁguration Commands

	Command			Description
#PRWEBADD			Displays the current IP conﬁguration
#RSTIP			Sets IP conﬁguration to factory settings
#SIPADD			Sets the IP Address
#SNETMASK			Sets the Net Mask
#SGATEWAY			Sets the Gateway
#SPORT			Sets the Port

#PRWEBADD Command

Prints the current IP conﬁguration on the screen.

Syntax:

#PRWEBADD

Parameters:

None

24

Image 27

Contents 1080P Write To Asking for AssistanceTechnical Support Technical Support HoursContents How It Works IntroductionGefen Gefen 16x16 3GSDI Push Button MatrixOperation Notes Features FeaturesPackage Includes Front Panel Front Panel LayoutFront Panel Descriptions Mode ButtonsBack Panel Back Panel LayoutBack Panel Descriptions Reference In ConnectorConnecting 16X16 3GSDI Push Button Matrix How to Connect the 16x16 3GSDI Push Button MatrixHow to Operate the 16x16 3GSDI Push Button Matrix Operating 16X16 3GSDI Push Button Matrix Standby ScreenDisplaying Additional Information Displaying the Current Routing State Routing Sources Mode ButtonsStandby Mode System Lock ModeCycling between Information Screens Saving the current Routing State Recalling a stored Routing State Masking Outputs Communication Modes RMT-16416IR Remote Control Unit IR Remote Control DescriptionsIR Remote Control Installation Installing the RMT-16416IR BatteryBattery Slot How to Resolve IR Code Conﬂicts IR Remote Control ConfigurationIR Remote Control Key Mapping Using the IR Remote ControlRS-232 Serial Interface How do I use these features?RS-232 Serial Control RS-232 FeaturesCommand Syntax #CHECKREF Command#PRWEBADD Command #PRREFTABLE Command#SIPADD Command #RSTIP Command#SGATEWAY Command #SNETMASK Command#SPORT Command General Commands#ACTIVEBOLO Command Command #FADEFAULT Command#RMTIRADD Command Routing CommandsParam1 param2 View Matrix Status IP ControlMasking IP Conﬁguration Backup / Restore Firmware Update Firmware UpdateSystem failure System FailureRack Mount Safety Information BNC SpecificationsProduct Registration WarrantyLicensing Rev A1