Gefen 1080P manual #RSTIP Command, #SIPADD Command

Page 28

RS-232 SERIAL CONTROL

#RSTIP Command

The #RSTIP command sets the current IP conﬁguration to factory (default) settings.

Syntax:

#RSTIP

Parameters:

None

Notes:

A reboot is required after using this command.

#SIPADD Command

The #SIPADD command speciﬁes a new IP address.

Syntax:

#SIPADD param1 param2 param3 param4

Parameters:
param1	IP address	[0 - 255]
param2	IP address	[0 - 255]
param3	IP address	[0 - 255]
param4	IP address	[0 - 255]

Notes:

A reboot is required after using this command.

25

Image 28

Contents 1080P Asking for Assistance Technical SupportTechnical Support Hours Write ToContents Introduction GefenGefen 16x16 3GSDI Push Button Matrix How It WorksOperation Notes Features FeaturesPackage Includes Front Panel Layout Front PanelMode Buttons Front Panel DescriptionsBack Panel Layout Back PanelReference In Connector Back Panel DescriptionsHow to Connect the 16x16 3GSDI Push Button Matrix Connecting 16X16 3GSDI Push Button MatrixHow to Operate the 16x16 3GSDI Push Button Matrix Standby Screen Operating 16X16 3GSDI Push Button MatrixDisplaying Additional Information Displaying the Current Routing State Mode Buttons Routing SourcesSystem Lock Mode Standby ModeCycling between Information Screens Saving the current Routing State Recalling a stored Routing State Masking Outputs Communication Modes IR Remote Control Descriptions RMT-16416IR Remote Control UnitInstalling the RMT-16416IR Battery IR Remote Control InstallationBattery Slot IR Remote Control Configuration How to Resolve IR Code ConﬂictsUsing the IR Remote Control IR Remote Control Key MappingHow do I use these features? RS-232 Serial InterfaceRS-232 Features Command Syntax#CHECKREF Command RS-232 Serial Control#PRREFTABLE Command #PRWEBADD Command#RSTIP Command #SIPADD Command#SNETMASK Command #SGATEWAY CommandGeneral Commands #SPORT Command#ACTIVEBOLO Command #FADEFAULT Command #RMTIRADD CommandRouting Commands CommandParam1 param2 IP Control View Matrix StatusMasking IP Conﬁguration Backup / Restore Firmware Update Firmware UpdateSystem Failure System failureRack Mount Safety Information Specifications BNCWarranty Product RegistrationLicensing Rev A1