Gefen 1080P IR Remote Control Installation, Installing the RMT-16416IR Battery, Battery Slot

Page 22

IR REMOTE CONTROL INSTALLATION

Installing the RMT-16416IR Battery

1.Remove the battery cover on the back of the IR Remote Control unit.

2.Insert the included battery into the open battery slot. The positive (+) side of the battery should be facing up.

3. Replace the battery cover.

The Remote Control unit ships with two batteries. One battery is required for operation and the other battery is a spare.

Battery Slot

WARNING: Risk of explosion if battery is replaced by an incorrect type. Dispose of used batteries according to the instructions.

19

Image 22

Contents 1080P Technical Support Hours Asking for AssistanceTechnical Support Write ToContents Gefen 16x16 3GSDI Push Button Matrix IntroductionGefen How It WorksOperation Notes Features FeaturesPackage Includes Front Panel Layout Front PanelMode Buttons Front Panel DescriptionsBack Panel Layout Back PanelReference In Connector Back Panel DescriptionsHow to Connect the 16x16 3GSDI Push Button Matrix Connecting 16X16 3GSDI Push Button MatrixHow to Operate the 16x16 3GSDI Push Button Matrix Standby Screen Operating 16X16 3GSDI Push Button MatrixDisplaying Additional Information Displaying the Current Routing State Mode Buttons Routing SourcesSystem Lock Mode Standby ModeCycling between Information Screens Saving the current Routing State Recalling a stored Routing State Masking Outputs Communication Modes IR Remote Control Descriptions RMT-16416IR Remote Control UnitInstalling the RMT-16416IR Battery IR Remote Control InstallationBattery Slot IR Remote Control Configuration How to Resolve IR Code ConﬂictsUsing the IR Remote Control IR Remote Control Key MappingHow do I use these features? RS-232 Serial Interface#CHECKREF Command RS-232 FeaturesCommand Syntax RS-232 Serial Control#PRREFTABLE Command #PRWEBADD Command#RSTIP Command #SIPADD Command#SNETMASK Command #SGATEWAY CommandGeneral Commands #SPORT Command#ACTIVEBOLO Command Routing Commands #FADEFAULT Command#RMTIRADD Command CommandParam1 param2 IP Control View Matrix StatusMasking IP Conﬁguration Backup / Restore Firmware Update Firmware UpdateSystem Failure System failureRack Mount Safety Information Specifications BNCWarranty Product RegistrationLicensing Rev A1