Gefen 1080P manual Operation Notes

Page 5

OPERATION NOTES

READ THESE NOTES BEFORE INSTALLING OR

OPERATING THE 16X16 3GSDI PUSH BUTTON MATRIX

There is no internal scaling in the 16x16 3GSDI Push Button Matrix. All of the attached monitors must be able to display the resolutions output by the source devices. For maximum compatibility it is recommended that only one compatible/common resolution be used by all of the source devices.

Routing features can be accessed using the serial control interface.

IP Control will be available in a future firmware release.

IMPORTANT: If the unit is installed in a closed or multi-rack assembly, do not block the ventilation holes of the enclosure.

2

Image 5
Contents 1080P Technical Support Asking for AssistanceTechnical Support Hours Write ToContents Gefen IntroductionGefen 16x16 3GSDI Push Button Matrix How It WorksOperation Notes Package Includes FeaturesFeatures Front Panel Front Panel LayoutFront Panel Descriptions Mode ButtonsBack Panel Back Panel LayoutBack Panel Descriptions Reference In ConnectorHow to Operate the 16x16 3GSDI Push Button Matrix Connecting 16X16 3GSDI Push Button MatrixHow to Connect the 16x16 3GSDI Push Button Matrix Displaying Additional Information Operating 16X16 3GSDI Push Button MatrixStandby Screen Displaying the Current Routing State Routing Sources Mode ButtonsStandby Mode System Lock ModeCycling between Information Screens Saving the current Routing State Recalling a stored Routing State Masking Outputs Communication Modes RMT-16416IR Remote Control Unit IR Remote Control DescriptionsBattery Slot IR Remote Control InstallationInstalling the RMT-16416IR Battery How to Resolve IR Code Conflicts IR Remote Control ConfigurationIR Remote Control Key Mapping Using the IR Remote ControlRS-232 Serial Interface How do I use these features?Command Syntax RS-232 Features#CHECKREF Command RS-232 Serial Control#PRWEBADD Command #PRREFTABLE Command#SIPADD Command #RSTIP Command#SGATEWAY Command #SNETMASK Command#ACTIVEBOLO Command #SPORT CommandGeneral Commands #RMTIRADD Command #FADEFAULT CommandRouting Commands CommandParam1 param2 View Matrix Status IP ControlMasking IP Configuration Backup / Restore Firmware Update Firmware UpdateSystem failure System FailureRack Mount Safety Information BNC SpecificationsProduct Registration WarrantyLicensing Rev A1