Gefen 1080P manual #SPORT Command, General Commands, #ACTIVEBOLO Command

Page 30

RS-232 SERIAL CONTROL

#SPORT Command

Speciﬁes a new port.

Syntax:

#SPORT param1

Parameters:
param1	Port	[0 - 255]

Notes:

A reboot is required after using this command.

General Commands

Command Description

#ACTIVEBOLO Enables the boot loader

#FADEFAULT Sets all routing states to default settings

#RMTIRADD Set the remote IR channel

#ACTIVEBOLO Command

The #ACTIVEBOLO command enables the boot loader.

Syntax:

#ACTIVEBOLO

Parameters:

None

Notes:

This command must be typed twice in order to activate the boot loader.

27

Image 30

Contents 1080P Technical Support Hours Asking for AssistanceTechnical Support Write ToContents Gefen 16x16 3GSDI Push Button Matrix IntroductionGefen How It WorksOperation Notes Features FeaturesPackage Includes Front Panel Layout Front PanelMode Buttons Front Panel DescriptionsBack Panel Layout Back PanelReference In Connector Back Panel DescriptionsConnecting 16X16 3GSDI Push Button Matrix How to Connect the 16x16 3GSDI Push Button MatrixHow to Operate the 16x16 3GSDI Push Button Matrix Operating 16X16 3GSDI Push Button Matrix Standby ScreenDisplaying Additional Information Displaying the Current Routing State Mode Buttons Routing SourcesSystem Lock Mode Standby ModeCycling between Information Screens Saving the current Routing State Recalling a stored Routing State Masking Outputs Communication Modes IR Remote Control Descriptions RMT-16416IR Remote Control UnitIR Remote Control Installation Installing the RMT-16416IR BatteryBattery Slot IR Remote Control Configuration How to Resolve IR Code ConﬂictsUsing the IR Remote Control IR Remote Control Key MappingHow do I use these features? RS-232 Serial Interface#CHECKREF Command RS-232 FeaturesCommand Syntax RS-232 Serial Control#PRREFTABLE Command #PRWEBADD Command#RSTIP Command #SIPADD Command#SNETMASK Command #SGATEWAY Command#SPORT Command General Commands#ACTIVEBOLO Command Routing Commands #FADEFAULT Command#RMTIRADD Command CommandParam1 param2 IP Control View Matrix StatusMasking IP Conﬁguration Backup / Restore Firmware Update Firmware UpdateSystem Failure System failureRack Mount Safety Information Specifications BNCWarranty Product RegistrationLicensing Rev A1