Gefen 1080P manual #SNETMASK Command, #SGATEWAY Command

Page 29

RS-232 SERIAL CONTROL

#SNETMASK Command

The #SNETMASK command speciﬁes a new net mask.

Syntax:

#SNETMASK param1 param2 param3 param4

Parameters:
param1	IP address	[0 - 255]
param2	IP address	[0 - 255]
param3	IP address	[0 - 255]
param4	IP address	[0 - 255]

Notes:

A reboot is required after using this command.

#SGATEWAY Command

Speciﬁes the new IP gateway.

Syntax:

#SGATEWAY param1 param2 param3 param4

Parameters:
param1	Gateway address	[0 - 255]
param2	Gateway address	[0 - 255]
param3	Gateway address	[0 - 255]
param4	Gateway address	[0 - 255]

Notes:

A reboot is required after using this command.

26

Image 29

Contents 1080P Technical Support Asking for AssistanceTechnical Support Hours Write ToContents Gefen IntroductionGefen 16x16 3GSDI Push Button Matrix How It WorksOperation Notes Package Includes FeaturesFeatures Front Panel Front Panel LayoutFront Panel Descriptions Mode ButtonsBack Panel Back Panel LayoutBack Panel Descriptions Reference In ConnectorHow to Operate the 16x16 3GSDI Push Button Matrix Connecting 16X16 3GSDI Push Button MatrixHow to Connect the 16x16 3GSDI Push Button Matrix Displaying Additional Information Operating 16X16 3GSDI Push Button MatrixStandby Screen Displaying the Current Routing State Routing Sources Mode ButtonsStandby Mode System Lock ModeCycling between Information Screens Saving the current Routing State Recalling a stored Routing State Masking Outputs Communication Modes RMT-16416IR Remote Control Unit IR Remote Control DescriptionsBattery Slot IR Remote Control InstallationInstalling the RMT-16416IR Battery How to Resolve IR Code Conﬂicts IR Remote Control ConfigurationIR Remote Control Key Mapping Using the IR Remote ControlRS-232 Serial Interface How do I use these features?Command Syntax RS-232 Features#CHECKREF Command RS-232 Serial Control#PRWEBADD Command #PRREFTABLE Command#SIPADD Command #RSTIP Command#SGATEWAY Command #SNETMASK Command#ACTIVEBOLO Command #SPORT CommandGeneral Commands #RMTIRADD Command #FADEFAULT CommandRouting Commands CommandParam1 param2 View Matrix Status IP ControlMasking IP Conﬁguration Backup / Restore Firmware Update Firmware UpdateSystem failure System FailureRack Mount Safety Information BNC SpecificationsProduct Registration WarrantyLicensing Rev A1