Force10 Networks CC-C-BLNK-LC manual Installing and Configuring the Switch, Unpacking the Switch

Unpacking the Switch

Package Contents

When unpacking each switch, make sure that the following items are included:

•One Dell Force10 MXL 10/40GbE Switch IO Module

•One USB type A-to-DB-9 female cable

•Getting Started Guide

•Safety and Regulatory Information

•Warranty and Support Information

•Software License Agreement

Unpacking Steps

NOTE: Before unpacking the switch, inspect the container and immediately report any evidence of damage.

1Place the container on a clean, flat surface and cut all straps securing the container.

2Open the container or remove the container top.

3Carefully remove the switch from the container and place it on a secure and clean surface.

4Remove all packing material.

5Inspect the product and accessories for damage.

Installing and Configuring the Switch

After you unpack the MXL 10/40GbE Switch, refer to the flow chart in Figure 1-6for an overview of the steps you must follow to install the blade and perform the initial configuration.

You can check to see that a switch is running the latest FTOS version by entering the show version command. To download an FTOS version, go to http://support.dell.com.

14

Installing and Configuring the Switch