Force10 Networks CC-C-BLNK-LC manual Technical Specifications, Chassis Physical Design

Page 34

Technical Specifications

The MXL 10/40GbE Switch is an I/O module and installed with Server (model: PowerEdge M1000e) for communication.

The product should be operated at an ambient temperature of 50°C.

CAUTION: Lithium Battery Caution: There is a danger of explosion if the battery is incorrectly replaced.

Replace only with same or equivalent type. Dispose batteries according to manufacturer's instructions.

Chassis Physical Design

Parameter	Specifications

Height	1.32 inches (33.45 mm)

Width	10.81 inches (274.75 mm)

Depth	12.17 inches (309.24 mm)

Environmental Parameters

Parameter	Specifications

Operating temperature	32° to 104°F (0° to 40°C)

Operating humidity	10 to 85% (RH), non-condensing

Storage temperature	–40° to 158°F (–40° to 70°C)

Storage humidity	5 to 95% (RH), non-condensing

Maximum thermal output	419.7 BTU/hr

34

Technical Specifications

Image 34

Contents Getting Started Guide June 2012 P/N WMDP6 Rev. A00 Contents Assembling a Switch Stack Introduction Product DescriptionInternal Ports Hardware OverviewFront Panel Base Module FlexIOTM Plug-in ModulesThen save the configuration and reload the switch Port Numbering USB Ports USB Ports on Front PanelSystem and Port LEDs Describes system LED conditionsPort LEDs on Modules Installation Site PreparationInstalling and Configuring the Switch Unpacking the SwitchInsert Switch Blade Power On Connect Console Yes Loader CLI Installing the Switch Blade in a PowerEdge M1000e PowerEdge M1000e Front View with Server BladesInstalling and Configuring the Switch Page Invoking the X-Loader and U-Boot CLIs Performing the Initial ConfigurationInitial Configuration Procedure Sample Setup Wizard Session Installing and Configuring the Switch Installing and Configuring the Switch Ftos Assembling a Switch Stack Six Stacked MXL 10/40GbE SwitchesConfiguring and Bringing Up a Stack Save the stacking configuration on the 40GbE ports Ftos enable FTOS# configure FTOSconf# stack-unit 0 priority Managing a StackAuto Stack Number Assignment Splitting 40GbE QSFP+ Ports into 10GbE SFP+ Ports Switch Configuration FCoE Connectivity DCB SupportISCSI Operation Next Steps Chassis Physical Design Technical SpecificationsEnvironmental Parameters Power Requirements Ieee StandardsTechnical Specifications Page W. d e l l . c o m s u p p o r t . d e l l . c o m