Force10 Networks CC-C-BLNK-LC manual Sample Setup Wizard Session

Page 21

Sample Setup Wizard Session

This section describes an Easy Setup Wizard session. The following values are used in the example session:

SNMP is enabled.

The default user name "root" and password "calvin" are used. The Wizard does not display the password as it is entered.

The OOB management interface uses IP address 192.168.2.1.

The default gateway uses IP address 192.168.2.0.

The default VLAN management interface uses IP address 2.2.2.80.

NOTE: In the example below, the previously entered value or the default value is enclosed within brackets [ ]. If you press <Enter> with no value selected, the value displayed in the brackets is used. Help text is in parentheses.

The following example contains the sequence of prompts and responses associated with running a sample Dell Easy Setup Wizard session, using the input values listed above.

After the switch initializes and boots up, the following text is displayed:

Welcome to Dell Easy Setup Wizard

The setup wizard guides you through the initial switch configuration, and gets you up and running as quickly as possible. You can skip the setup wizard, and enter CLI mode to manually configure the switch. You must respond to the next question to run the setup wizard within 60 seconds, otherwise the system will continue with normal operation using the default system configuration. Note: You can exit the setup wizard at any point by entering [Ctrl+c].

Would you like to run the setup wizard (you must answer this question within 60 seconds)? [Y/N] y

The system is not set up for SNMP management by default. To manage the switch using SNMP (required for Dell Network Manager) you can

Installing and Configuring the Switch

21

Image 21
Contents Getting Started Guide June 2012 P/N WMDP6 Rev. A00 Contents Assembling a Switch Stack Product Description IntroductionHardware Overview Internal PortsFront Panel FlexIOTM Plug-in Modules Base ModuleThen save the configuration and reload the switch Port Numbering USB Ports on Front Panel USB PortsDescribes system LED conditions System and Port LEDsPort LEDs on Modules Site Preparation InstallationUnpacking the Switch Installing and Configuring the SwitchInsert Switch Blade Power On Connect Console Yes Loader CLI PowerEdge M1000e Front View with Server Blades Installing the Switch Blade in a PowerEdge M1000eInstalling and Configuring the Switch Page Performing the Initial Configuration Invoking the X-Loader and U-Boot CLIsInitial Configuration Procedure Sample Setup Wizard Session Installing and Configuring the Switch Installing and Configuring the Switch Ftos Six Stacked MXL 10/40GbE Switches Assembling a Switch StackConfiguring and Bringing Up a Stack Save the stacking configuration on the 40GbE ports Managing a Stack Ftos enable FTOS# configure FTOSconf# stack-unit 0 priorityAuto Stack Number Assignment Splitting 40GbE QSFP+ Ports into 10GbE SFP+ Ports Switch Configuration DCB Support FCoE ConnectivityISCSI Operation Next Steps Technical Specifications Chassis Physical DesignEnvironmental Parameters Ieee Standards Power RequirementsTechnical Specifications Page W. d e l l . c o m s u p p o r t . d e l l . c o m