Force10 Networks CC-C-BLNK-LC manual Power Requirements, Ieee Standards

Page 35

Power Requirements

Parameter	Specifications

Power supply	100–240 VAC 50/60 Hz

Maximum current draw per system	2 A @ 100/120 VAC
	1 A @ 200/40 VAC

Maximum power consumption	123 Watts

Reliability	MTBF 355,178 hours

IEEE Standards

The MXL 10/40GbE Switch complies with the following IEEE standards:

•802.1AB LLDP

•802.1ag Connectivity fault Management

•802.1D Bridging, STP

•802.1p L2 Prioritization

•802.1Q VLAN Tagging, Double VLAN Tagging, GVRP

•802.1s MSTP

•802.1w RSTP

•802.3ab Gigabit Ethernet (1000BASE-T)

•802.3ac Frame Extensions for VLAN Tagging

•802.3ad Link Aggregation with LACP

•802.3ae 10 Gigabit Ethernet (10GBASE-X)

•802.3ba 40 Gigabit Ethernet (40GBase-SR4, 40GBase-CR4) on optical ports

•802.3u Fast Ethernet (100BASE-TX)

•802.3x Flow Control

•802.3z Gigabit Ethernet (1000BASE-X)

•ANSI/TIA-1057 LLDP-MED

•Force10 PVST+

•MTU 12K bytes

Technical Specifications

35

Image 35

Contents Getting Started Guide June 2012 P/N WMDP6 Rev. A00 Contents Assembling a Switch Stack Product Description IntroductionFront Panel Hardware OverviewInternal Ports FlexIOTM Plug-in Modules Base ModuleThen save the configuration and reload the switch Port Numbering USB Ports on Front Panel USB PortsDescribes system LED conditions System and Port LEDsPort LEDs on Modules Site Preparation InstallationUnpacking the Switch Installing and Configuring the SwitchInsert Switch Blade Power On Connect Console Yes Loader CLI PowerEdge M1000e Front View with Server Blades Installing the Switch Blade in a PowerEdge M1000eInstalling and Configuring the Switch Page Performing the Initial Configuration Invoking the X-Loader and U-Boot CLIsInitial Configuration Procedure Sample Setup Wizard Session Installing and Configuring the Switch Installing and Configuring the Switch Ftos Six Stacked MXL 10/40GbE Switches Assembling a Switch StackConfiguring and Bringing Up a Stack Save the stacking configuration on the 40GbE ports Managing a Stack Ftos enable FTOS# configure FTOSconf# stack-unit 0 priorityAuto Stack Number Assignment Splitting 40GbE QSFP+ Ports into 10GbE SFP+ Ports Switch Configuration ISCSI Operation DCB SupportFCoE Connectivity Next Steps Environmental Parameters Technical SpecificationsChassis Physical Design Ieee Standards Power RequirementsTechnical Specifications Page W. d e l l . c o m s u p p o r t . d e l l . c o m