Force10 Networks CC-C-BLNK-LC manual Installing and Configuring the Switch

Page 23

Next, IP addresses are set up on the OOB (Out-Of-Band) Interface and/or the VLAN1 routing interface.

You can use these IP addresses to access the CLI, Web interface, or SNMP interface of the switch.

To access the switch through any Management Interface you can

. set up the IP address for the Management Interface.

. set up the default gateway if IP address is manually configured on the OOB interface.

Would you like to set up the Out-Of-Band interface now? [Y/N] y

Please enter the IP address of the device (A.B.C.D) or enter "DHCP" (without the quotes) to automatically request an IP address from the network DHCP server. [192.168.2.1]: 192.168.2.1

Please enter the IP subnet mask (A.B.C.D or /nn). [255.255.255.0]: 255.255.255.0

Please enter the IP address of the default gateway from which this network is reachable. 0.0.0.0 means that the default gateway will not be configured [0.0.0.0]: 192.168.2.0

Would you like to set up the VLAN1 routing interface now? [Y/N] y

Please enter the IP address of the device (A.B.C.D) or enter "DHCP" (without the quotes) to automatically request an IP address from the network DHCP server. : 2.2.2.80

Please enter the IP subnet mask (A.B.C.D or /nn). : 255.255.255.0

Installing and Configuring the Switch

23

Image 23
Contents Getting Started Guide June 2012 P/N WMDP6 Rev. A00 Contents Assembling a Switch Stack Product Description IntroductionFront Panel Hardware OverviewInternal Ports FlexIOTM Plug-in Modules Base ModuleThen save the configuration and reload the switch Port Numbering USB Ports on Front Panel USB PortsDescribes system LED conditions System and Port LEDsPort LEDs on Modules Site Preparation InstallationUnpacking the Switch Installing and Configuring the SwitchInsert Switch Blade Power On Connect Console Yes Loader CLI PowerEdge M1000e Front View with Server Blades Installing the Switch Blade in a PowerEdge M1000eInstalling and Configuring the Switch Page Performing the Initial Configuration Invoking the X-Loader and U-Boot CLIsInitial Configuration Procedure Sample Setup Wizard Session Installing and Configuring the Switch Installing and Configuring the Switch Ftos Six Stacked MXL 10/40GbE Switches Assembling a Switch StackConfiguring and Bringing Up a Stack Save the stacking configuration on the 40GbE ports Managing a Stack Ftos enable FTOS# configure FTOSconf# stack-unit 0 priorityAuto Stack Number Assignment Splitting 40GbE QSFP+ Ports into 10GbE SFP+ Ports Switch Configuration ISCSI Operation DCB SupportFCoE Connectivity Next Steps Environmental Parameters Technical SpecificationsChassis Physical Design Ieee Standards Power RequirementsTechnical Specifications Page W. d e l l . c o m s u p p o r t . d e l l . c o m