Eizo L461 manual Off Timer, Procedure, Off timer system

Page 17

Off Timer

The off timer function causes the monitor to automatically enter a power off mode after a predetermined amount of time has lapsed. This function was created to reduce afterimage p.35) characteristics that are particular to LCD monitors when the monitor screen is left on for a long period without use.

[Procedure]

(1)Select “Off Timer” in the ScreenManager “Others” menu.

(2)Select “Enable” and press the right and left buttons to adjust the “On Period” (1 to 23 hours).

[Off timer system]

PC

Monitor

LED

 

 

 

On Period (1H~23H)

Operation

Green

 

 

 

Last 15 min. in "On period"

Advance Notice *1

Green Flashing

 

 

 

"On period" expired

"Power Off" Mode

Flashing yellow slowly

 

 

 

*1Advance notice (LED flashing green) will be given 15 minutes before the monitor automatically enters the “Power Off” mode. To delay entering the “Power Off” mode, press the power switch during the advance notice period. The monitor will continue to operate for an additional 90 minutes.

Press the power switch to return to a normal screen.

The off timer function works while the PowerManager is active, but there is no advance notice before the monitor’s power is switched off.

ENGLISH

3. ScreenManager 17

Image 17
Contents English Safety Symbols Table of Contents ´ Do not dismantle the cabinet or modify the unit Precautions´ Refer all servicing to qualified service personnel ´ Place the unit on a strong, stable surface Keep small objects or liquids away from the unit´ Set the unit in an appropriate location ´ The equipment must be connected to a grounded main outlet´ Do not touch a damaged LCD panel directly with bare hands ´ Handle the power cord with care´ Use the correct voltage ´ Use an easily accessible power outlet ´ Handle with care when carrying the unit´ Periodically clean the area around the plug ´ Unplug the unit before cleaning itLCD Panel Suggestions for Maximizing ComfortIntroduction FeaturesPackage Contents Rear Controls & ConnectorsFront Cable Connection Before connectingAnalog Input Digital InputDigital Input Connecting the signal cableAnalog Input Equipment must be connected to a grounded main Outlet ScreenManager How to use the ScreenManagerMain menu Sub menu Reference ScreenManager Adjustments and SettingsEizo Logo Disappearing function Adjustment LockUseful Functions Off timer system Off TimerProcedure Screen Adjustment AdjustmentHorizontal flickering, blurring or bars appear on the screen Screen position is incorrect Use the Position adjustment Auto Displaying the low resolutions English Before the Color adjustment Color AdjustmentTo change the saturation Use the Saturation adjustment Power saving system Power-save SetupAttaching AN ARM Stand Setup Procedure28 5. Attaching AN ARM Stand Problems Points to check with possible solutions Troubleshooting30 6.TROUBLESHOOTING Button does not operate Auto adjustment Auto adjustmentChange after installing Fingerprints remain onCabinet CleaningVesa DDC 2B SpecificationsDefault Settings DimensionsGain Adjustment Color Temperature TemperatureGlossary AfterimageResolution PhaseRange Adjustment 17,35 IndexMemo Pin Assignment Pin-Belegung Affectation des Broches Appendix / Anhang / AnnexeIi Appendix 480 800 525 907 111 356 556 25.422 12.712 31.778 14.267 180 Iv Appendix What does labelling involve? Why do we have environmentally labelled computers?Congratulations Cadmium Environmental requirements Flame retardantsMercury CFCs freonsPhone 562 431 We, the Responsible PartyWarland Drive, Cypress, CA