Fortinet FortiGate-5000 manual Zre, Clk

Front panel LEDs and connectors FortiSwitch-5003 system

Figure 27: FortiSwitch-5003 front panel

Power LED
Management	CONSOLE	ZRE Network	LED Mode Switch
100Base-TX	RJ-45	Activity LEDs	Reset
Ethernet	Serial	(ZRE 0 to 15)
			Switch

MANAGEMENT

E T H O

R S 2 3 2

Z R E 0

Z R E 1

Z R E 2

E0 E1

SYSTEM

CONSOLE

14 15

12 13

10 11

8 9

Extraction		ZRE0 ZRE1 ZRE2
Lever	Out of	base backplane interfaces
Mounting	Service LED	10/100/1000Base-T
Knot		Ethernet

7	5	3	1		OK	INT FLT	HOT SWAP	RESET
				ZRE
6	4	2	0		CLK	EXT FLT

Hot

Swap

LED

LED MODE

Extraction

Lever

Mounting

Knot

LEDs

Table 21 lists and describes the FortiSwitch-5003 board front panel LEDs.

Table 21: FortiSwitch-5003 board front panel LEDs and switches

LED	State	Description
	Off	Normal operation.
	Red	Out of service. The LED turns on if the FortiSwitch-5003 board
		fails. The LED may also flash briefly when the board is
		powering on.
	Green	The FortiSwitch-5003 board is powered on and operating
		normally.
	Yellow	Caution status. Caution status is indicated by the fault condition
		of the CLOCK, OK or INT FLT LEDs.
	Off	The board is not connected to power.
System	Off	Normal operation.
E0, E1	Yellow or	Link status of out of band management interfaces (not used).
	Green
ZRE 0-15	Green	Link/Activity mode: Blinking to indicate network traffic on this
(ZRE		interface. Table 22 on page 63 lists the ZRE LEDs and the
network		interface that each represents.
		Link/Speed mode: 100 Mbps connection.
activity
LEDs, LED	Yellow	Link/Activity mode: The interface is disabled and cannot
Mode		forward packets. (not used)
switch		Link/Speed mode: 1000 Mbps connection.
changes	Off	Link/Activity mode: No link.
mode)		Link/Speed mode: 10 Mbps connection.
LED Mode	Change the	ZRE network activity LED display mode. Normally the ZRE
switch	network activity LEDs operate in Link/Activity mode. In this mode the LEDs
	flash green to indicate a link and to indicate network traffic.
	Press this button to switch the ZRE LEDs to Link/Speed mode. In
	Link/Speed mode the ZRE LEDs use a solid color to indicate a link. The
	color of the LED indicates the speed of the link.
CLK	Flashing	Initialization completed successfully.
	Green
OK	Green	Initialization completed successfully.

FortiGate-5000 Series Introduction

62 01-30000-83466-20090108