Fortinet FortiGate-5000 manual Lists and describes the FortiGate-5001FA2-LENC board LEDs, Pwr, Sta

Front panel LEDs and connectors FortiGate-5001FA2-LENC security system

•Mounting hardware

•LED status indicators

The FortiGate-5001FA2-LENC board comes supplied with four optical or four copper SFP transceivers. Before you can connect FortiGate-5001FA2-LENC interfaces 1 to 4, you must insert the SFP transceivers into the FortiGate-5001FA2-LENC front panel cage slots numbered 1 to 4.

The FortiGate-5001FA2-LENC board ships with two RAM DIMMs installed on the FortiGate-5001FA2-LENC circuit board. You should confirm that the RAM DIMMs are installed correctly before inserting the FortiGate-5001FA2-LENC board into a chassis.

Front panel LEDs and connectors

From the FortiGate-5001FA2-LENC font panel you can view the status of the front panel LEDs to verify that the board is functioning normally. You also connect the FortiGate-5001FA2-LENC board to your network through the front panel ethernet connectors. The front panel also includes the RS-232 console port for connecting to the FortiOS CLI and a USB port. The USB port can be used with a Fortinet USB key. For information about using the FortiUSB key, see the FortiGate-5000 Series Firmware and FortiUSB Guide.

LEDs

Table 12 lists and describes the FortiGate-5001FA2-LENC board LEDs.

Table 12: FortiGate-5001FA2-LENC board LEDs

LED	State	Description
PWR	Green	The FortiGate-50012FA2 board is powered on.
ACC	Off or	The ACC LED flashes red when the
	Flashing	FortiGate-5001FA2-LENC board accesses the FortiOS flash
	red	disk. The FortiOS flash disk stores the current FortiOS
		firmware build and configuration files. The system accesses
		the flash disk when starting up, during a firmware upgrade, or
		when an administrator is using the CLI or GUI to change the
		FortiOS configuration. Under normal operating conditions this
		LED flashes occasionally, but is mostly off.
STA	Green	Normal operation.
	Red	The FortiGate-5001FA2-LENC is booting or a fault condition
		exists.
IPM	Blue	The FortiGate-5001FA2-LENC is ready to be hot-swapped
		(removed from the chassis). If the IPM light is blue and no
		other LEDs are lit the FortiGate-5001FA2-LENC board has
		lost power, possibly because of a loose or incorrectly aligned
		left handle.
	Flashing	The FortiGate-5001FA2-LENC is changing from hot swap to
	Blue	running mode or from running mode to hot swap.
	Off	Normal operation. The FortiGate-5001FA2-LENC board is in
		contact with the chassis backplane.
1, 2, 3, 4	Green	The correct cable is connected to the gigabit SFP interface.
	Flashing	Network activity at the gigabit SFP interface.

	FortiGate-5000 Series Introduction
46	01-30000-83466-20090108