Fortinet FortiGate-5000 manual Lists and describes the FortiController-5208 board LEDs, Data

Front panel LEDs and connectors FortiController-5208 system

•Inserting a FortiController-5208 module into a chassis

•Removing a FortiController-5208 module from a chassis

•Troubleshooting

Front panel LEDs and connectors

From the FortiController-5208 front panel you can view the status of the board LEDs to verify that the board is functioning normally. LEDs also indicate connections and traffic for the front panel and backplane interfaces. You also connect the FortiController-5208 board to your network through the front panel XFP and SFP connections. The front panel also includes two RJ-45 serial console ports for connecting to the FortiController-5208 CLI and an Ethernet RJ-45 port for connecting to the CLI and GUI management interfaces over a network.

Figure 34: FortiController-5208 front panel

									SFP Gigabit
									Fiber or Copper
X1 X2 XFP 10 Gigabit											D15		Management
									1	3		C15
Fiber or Copper													RJ-45 Serial
			DATA				CONTROL
X 1	X 2	1	5	9	13	1	5	9	13			1	COM 1	COM 2
			6	10		2	6	10	14			MANAGEMENT
X 1		2			14					3/4	D15/D16	2
		3	7	11	D 15	3	7	11	1/2			C15/C16
									C 15			3
X 2		4	8	12 D 16		4	8	12	C 16			4
		10/100/1000 MBPS ETHERNET ACTIVITY
STATUS	PAYLOAD OPERATION												IPM

Mounting		Link/Traffic 2 4	C16	Mounting
	Status
Knot			D16	Knot
Extraction			IPM	Extraction
Lever			Management	Lever
	Link/ Payload
	Traffic Operation		RJ-45 Ethernet

LEDs

Table 25 lists and describes the FortiController-5208 board LEDs.

Table 25: FortiController-5208 board LEDs

LED		State	Description
X1, X2		Green	The correct cable is connected to the 10 gigabit
			XFP interface.
STATUS		Off	The STATUS LED is always off, even when the
			FortiController-5208 board is starting or operating
			normally.
PAYLOAD OPERATION		Green
DATA	1-16	Green	The data LEDs display base backplane connections
			of the FortiController-5208 board and the 5005
			boards, over which the load-balanced traffic is sent.
			LED 1 corresponds to the FortiController-5208
			board’s connection, LEDs 3 through 14 are for
			connections to the corresponding slots in a 5050 or
			5140 chassis. LEDs 15 and 16 are for the HA ports
			D15/D16 on the front panel. Due to the organization
			of the backplane, LED 2 will always be off, even if
			an operating FortiController-5208 is in slot 2.

	FortiGate-5000 Series Introduction
74	01-30000-83466-20090108