Falcon SG3KRM-2TU, SG3KRM-1TU, SG2KRM-1TU Storing the UPS and Batteries, FCC Considerations

Page 21

The following precautions should be observed by a qualified technician when working with batteries.

1.Remove watches, rings, or other metal objects.

2.Use tools with insulated handles.

3.Wear rubber gloves and boots.

4.Do not lay tools or metal parts on top of batteries.

4.Storing the UPS and Batteries

Should you need to store the UPS for a long period, fully recharge the battery just prior to storage and recharge the battery every 4 months by plugging the UPS into a power outlet. It is recommended that the batteries charge for 24 hours after long-term storage.

5.FCC Considerations

This equipment generates and uses radio frequency energy and if not installed and used properly in strict accordance with the manufacturer's instructions, may cause interference to radio and television reception. All models covered in this manual have been tested and found to comply with the limits for a Class A computing device, in accordance with the specifications in FCC regulations, Part 15, Subpart J, which are designed to provide reasonable protection against such interference.

If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

a.Reorient or relocate the receiving antenna.

b.Increase the separation between the equipment and the receiver.

c.Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

d.Consult the dealer or an experienced radio/television technician for assistance.

19

Image 21
Contents Owners Operating Manual Table of Contents SG Series ON-LINE UPS System Block Diagram Important Safety Instructions Extended Battery Bank Option Input Power Factor CorrectionTrue Regenerative On-Line Design Microprocessor ControlRackmount UPS Mounting Instructions --- Important SG Rackmount Installation InstructionsGreen Mode Disabled Enabled No Battery Backup is Provided When in this Mode100-120V 200-240V Models OnlyUPS Battery Module Interconnect WiringPage Slide Mounting Details Optional Slide Mounting KIT SgrmkitFor 1KVA Models SG Rackmount Extended Battery Bank Selection GuideOperation UPS Front Panel Indicator and Function KeysInverter Indicator LED Audible Alarms Category one alarmsCategory two alarms All models Front & Rear Panel DetailsSG1KRM-1TU SG1KRM-2TUSG2KRM-1TU & SG3KRM-1TU Typical Rear Panel OverviewSG2KRM-2TU & SG3KRM-2TU Typical Rear Panel Overview Location Communications InterfacesSupported Protocols RS-232 InterfacePIN & Jumper Assignment for the Falcon DRY Contact & Opto Coupler Interface Board OptionsUA88374 Relay Option Board UA88376 Relay Option BoardTypical Falcon Opto-coupler Interface Card No-bypass signalPIN Assignment for the Falcon UA88373 OPTO-COUPLER Option BoardCare & Maintenance Battery Life vs. TemperatureBattery Replacement FCC Considerations Storing the UPS and BatteriesRequesting Technical Information or Support Technical SupportSUPPORT@FALCONUPS.COM 800.842.6940 Falcon Web SupportGeneral Provisions Limited NEW Product Warranty AgreementSG SeriesTM UPS Plus