SG Rackmount Installation Instructions

CHAPTER 2

1.Verify the following is included in the UPS shipping carton: * UPS

*Software Diskette(s) & Manual *Power Cord

*Owners Manual

*UPS/Computer Cable

*Box containing mounting brackets, handles & mounting hardware

*SG2KRM-1TU, SG2KRM-2TU, SG3KRM-1TU & SG3KRM-2TU do not have batteries inside the UPS enclosure and are shipped with an additional rackmount battery module. Verify the battery interconnect cable and another small box containing mounting brackets, handles and mounting hardware are present inside the battery module shipping carton..

2.Verify the UPS unit is configured for the proper input/output voltage and frequency. This information is stated on the nameplate label located on the rear or the side panel of the unit. If any special input plug and output receptacle configurations were specified at the time of order, verify for proper configuration

3.RACKMOUNT UPS MOUNTING INSTRUCTIONS --- IMPORTANT---

a.NEVER MOUNT THE UPS OR ANY ASSOCIATED BATTERY BANKS USING ONLY THE FRONT PANEL MOUNTING EARS AS DAMAGE WILL RESULT! All Falcon rackmount UPS and battery modules are designed to be supported by a shelf mounted to both front and rear rails of the rack. Shelves are available from the manufacturer of your particular rack enclosure. Select a shelf that can support 150 pounds of weight, minimum.

b.Use the following instructions to assemble the supplied mounting brackets and handles, and to install the bracket assemblies to the UPS, and battery module (if supplied).

Step 1.

Locate the mounting hardware kit(s)

Step 3. Using two Flat Head screws, fasten the chrome handles to each bracket

Step 2.

Remove the screws from their plastic bag and identify.

Flat Head		Pan Head

Step 4.

Using the remaining Pan Head screws, fasten the bracket assembly to both sides of the UPS and battery banks (if supplied).