Battery Module Interconnect Wiring, Ups

5.For all 1kVA & (-2) 2-3kVA models, connect the power cord to the UPS inlet located on the UPS rear panel. On (-1) 2 & 3Kva models the line cord is permanently attached to the UPS.

6.Connect the power cord(s) for the equipment to be protected to the UPS output receptacles.

7.For all 2 & 3kVA models remove the two screws securing the battery connector cover plate on the UPS module rear panel. Next remove the two screws securing the upper battery connector cover plate located on the battery module rear panel. Connect one end of the battery interconnect cable to the mating battery connector on the UPS. On the primary battery bank remove the battery fuse and connect the other end of the battery cable to the upper battery connector (located on the battery bank rear panel). Depress and hold the precharge pudhbutton while reinstalling the battery fuse

8.If additional extended battery modules are to be installed, perform the following:

a.Perform the preperation outlined in preceding paragraphs 3a, 3b, abd 3c.

b.Connect the supplied battery interconnect cable(s). Connect one end of the battery interconnect cable to the mating lower battery connector on the first battery module. On extended battery bank, depress the pre-charge pushbutton located on the rear panel, and hold while connecting the other end of the battery cable to the upper extended battery connector (located on the battery bank rear panel). For addition extended battery modules repeat step 8.

BATTERY MODULE INTERCONNECT WIRING

UPS		UPS Battery
		Connector

Standard 2 & 3Kva battery Module or Optional 1Kva extended battery module

Battery

Interconnect

Cable

Battery

Interconnect

Cable

Optional extended battery module

Battery

Interconnect

Typical battery fuse

Typical Battery/UPS pre-charge push-		Lower cover
button		plate shown