Enterasys Networks manual C2RPS-POE Overview, C2RPS-POE Status LED

Page 18

C2RPS-POE Overview

C2RPS-POE Overview

The purpose of the C2RPS‐POE is to provide power backup to an Enterasys SecureStack C2 PoE‐compliant stackable switch. If for some reason the switch looses power from its internal power supply, the C2RPS‐POE can provide up to 500 Watts maximum operating power to support switch operation and the 48 Vdc cessary to support 48 Vdc/data connections to PDs (Powered Devices).

The C2RPS‐POE is shown in Figure 1‐1.

Figure 1-1 SecureStack C2RPS-POE (front and rear view)

C2RPS-POE

POWER

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Ä

Á

À

Ä

Ä

 

 

Ã

Ä

AC LINE

100-240 VAC

50-60 Hz

10.0 A MAX

Redundant Power Supply

DC Line -50V /7.5A MAX,

+12V /10.5A MAX

SERIAL NO.

 

Å

 

Â

1

C2RPS-POE (front view)

4

C2RPS-POE (rear view)

2

LED status indicator

5

Air vents for cooling

3

Redundant Power Supply connector

6

AC power input connector

C2RPS-POE Status LED

The C2RPS‐POE has one status LED located on the front panel, which indicates the following:

LED on = RPS operating properly

LED off = RPS failed

Power Classifications and Deployment

Each PD has a Power Classification that indicates how much power it will consume as shown in Table 1‐1. This information is sent through the data cable connected to the port of a SecureStack PoE switch for power management purposes. The C2RPS‐POE can supply up to 500 Watts of power, 370 Watts maximum to support PD connections and 130 Watts for switch operation. The 370 Watts is managed separately from the 130 Watts for switch operation.

1-2 Introduction

Image 18
Contents SecureStack C2 PoE Redundant Power Supply Page Page Regulatory Compliance Information Electromagnetic Compatibility EMC Declaration of Conformity Enterasys Networks, Inc Firmware License Agreement Page Vii Viii Contents Tables Using This Guide About this GuideStructure of This Guide Using the SecureStack C2 Manual Set Conventions Used in This Guide Following conventions are used in this guideConventions Used in This Guide Xiv About this Guide Introduction For information about Refer toPower Classifications and Deployment C2RPS-POE OverviewC2RPS-POE Status LED Example of a C2RPS-POE Power Configuration Getting Help Support@enterasys.comInstallation Required ToolsInstalling the C2RPS-POE on a Flat Surface Contents of N-POE Chassis Carton QuantityUnpacking the C2RPS-POE Installing the Rubber Feet Guidelines for Installation Guidelines for Rackmount Installation Rack Mounting the C2RPS-POEAttaching Brackets and Installing in Rack Connecting C2RPS-POE Cable and AC Power Cord C2RPS-POE Status LED Indications and Recommended ActionsColor State Recommended Action C2RPS-POE Cable C2RPS-POE Cable and AC Power Cord Connections Connecting C2RPS-POE Cable and AC Power Cord Installation Specifications C2RPS-POE SpecificationsTable A-1 C2RPS-POE Specifications Electrical C2RPS-POE Redundant Power Supply Output Connector Table A-1 C2RPS-POE Specifications PhysicalEnvironmental Compliance Standards Table A-3 Compliance StandardsCompliance Standards Specifications