Enterasys Networks C2RPS-POE manual

Page 3

Electrical Hazard: Only qualified personnel should perform installation procedures.

Riesgo Electrico: Solamente personal calificado debe realizar procedimientos de instalacion.

Elektrischer Gefahrenhinweis: Installationen sollten nur durch ausgebildetes und qualifiziertes Personal vorgenommen werden.

Notice

Enterasys Networks reserves the right to make changes in specifications and other information contained in this document and its web site without prior notice. The reader should in all cases consult Enterasys Networks to determine whether any such changes have been made.

The hardware, firmware, or software described in this document is subject to change without notice.

IN NO EVENT SHALL ENTERASYS NETWORKS BE LIABLE FOR ANY INCIDENTAL, INDIRECT, SPECIAL, OR CONSEQUENTIAL DAMAGES WHATSOEVER (INCLUDING BUT NOT LIMITED TO LOST PROFITS) ARISING OUT OF OR RELATED TO THIS DOCUMENT, WEB SITE, OR THE INFORMATION CONTAINED IN THEM, EVEN IF ENTERASYS NETWORKS HAS BEEN ADVISED OF, KNEW OF, OR SHOULD HAVE KNOWN OF, THE POSSIBILITY OF SUCH DAMAGES.

Enterasys Networks, Inc.

50 Minuteman Road

Andover, MA 01810

2005 Enterasys Networks, Inc. All rights reserved. Part Number: 9033995‐01 April 2005

ENTERASYS, ENTERASYS NETWORKS, ENTERASYS MATRIX, LANVIEW, MATRIX, NETSIGHT, WEBVIEW, and any logos associated therewith, are trademarks or registered trademarks of Enterasys Networks, Inc., in the United States and other countries.

All other product names mentioned in this manual may be trademarks or registered trademarks of their respective companies.

Documentation URL: http://www.enterasys.com/support/manuals

Documentacion URL: http://www.enterasys.com/support/manuals

Dokumentation http://www.enterasys.com/support/manuals

i

Image 3
Contents SecureStack C2 PoE Redundant Power Supply Page Page Regulatory Compliance Information Electromagnetic Compatibility EMC Declaration of Conformity Enterasys Networks, Inc Firmware License Agreement Page Vii Viii Contents Tables Using This Guide About this GuideStructure of This Guide Using the SecureStack C2 Manual Set Following conventions are used in this guide Conventions Used in This GuideConventions Used in This Guide Xiv About this Guide For information about Refer to IntroductionPower Classifications and Deployment C2RPS-POE OverviewC2RPS-POE Status LED Example of a C2RPS-POE Power Configuration Support@enterasys.com Getting HelpRequired Tools InstallationInstalling the C2RPS-POE on a Flat Surface Contents of N-POE Chassis Carton QuantityUnpacking the C2RPS-POE Installing the Rubber Feet Guidelines for Installation Rack Mounting the C2RPS-POE Guidelines for Rackmount InstallationAttaching Brackets and Installing in Rack Connecting C2RPS-POE Cable and AC Power Cord C2RPS-POE Status LED Indications and Recommended ActionsColor State Recommended Action C2RPS-POE Cable C2RPS-POE Cable and AC Power Cord Connections Connecting C2RPS-POE Cable and AC Power Cord Installation Specifications C2RPS-POE SpecificationsTable A-1 C2RPS-POE Specifications Electrical C2RPS-POE Redundant Power Supply Output Connector Table A-1 C2RPS-POE Specifications PhysicalEnvironmental Table A-3 Compliance Standards Compliance StandardsCompliance Standards Specifications