Enterasys Networks C2RPS-POE manual Attaching Brackets and Installing in Rack

Rack Mounting the C2RPS-POE

Attaching Brackets and Installing in Rack

Proceed as follows to install the switch into a 19‐inch rack:

1.Attach the rackmount brackets to the switch, as shown in Figure 2‐3, using the eight M3 x 6 mm flathead screws shipped with the switch.

Figure 2-3 Attaching the Rackmount Brackets

C2RPS-POE

POWER

Á À	À	Á
1 Rackmount brackets (2)	2 M3 x 6 mm flathead screws (8)

2.With the mounting brackets attached, position the switch between the vertical frame members of the 19‐inch rack as shown in Figure 2‐4. Then fasten the C2RPS‐POE securely to the frame using four mounting screws (user supplied).

Figure 2-4 Fastening the C2RPS-POE to the Rack

C2RPS-POE

POWER

Á	Á
À		À
1 Rails of 19-inch rack	2 Mounting screws (supplied by user)

3.If you are installing the C2RPS‐POE in a stacked configuration, repeat this procedure for each C2RPS‐POE, then proceed to “Connecting C2RPS‐POE Cable and AC Power Cord” on page 2‐7.

2-6 Installation