Enterasys Networks manual Unpacking the C2RPS-POE, Installing the C2RPS-POE on a Flat Surface

Page 22

Unpacking the C2RPS-POE

Unpacking the C2RPS-POE

To unpack the C2RPS‐POE, proceed as follows:

1.Open the box and remove the packing material protecting the devices.

2.Verify the contents of each carton and compare the contents shipped with those listed in Table 2‐1.

3.Perform a visual inspection of the devices for any signs of physical damage. Contact Enterasys Networks if there are any signs of damage. Refer to Getting Help” on page 1‐4 for details.

Table 2-1 Contents of N-POE Chassis Carton

Item

Quantity

 

 

C2RPS-POE Cable

1

 

 

Rubber Foot

4

 

 

Flathead screw M3x6

6

 

 

Rack mount bracket

1

 

 

USA, NEMA Power Cord

1

 

 

Installation guide

1

 

 

Release Notes

1

 

 

Installing the C2RPS-POE on a Flat Surface

Caution: Observe all Electrostatic Discharge (ESD) precautions when handling sensitive electronic equipment.

Precaución: Al trabajar con equipos electrónicos sensibles, tome todas las precauciones de seguridad para evitar descargas de electricidad estática.

When installing the switch on a flat surface, the installation of the rubber feet is recommended to prevent the C2RPS‐POE from sliding on a flat surface. Installing the rubber feet is optional if you are installing the C2RPS‐POE in a rack. To install the rubber feet, proceed to Installing the Rubber Feet instructions below. For instructions to rack mount the switch, proceed to Rack Mounting the C2RPS‐POE” on page 2‐5.

2-2 Installation

Image 22
Contents SecureStack C2 PoE Redundant Power Supply Page Page Regulatory Compliance Information Electromagnetic Compatibility EMC Declaration of Conformity Enterasys Networks, Inc Firmware License Agreement Page Vii Viii Contents Tables About this Guide Using This GuideStructure of This Guide Using the SecureStack C2 Manual Set Conventions Used in This Guide Following conventions are used in this guideConventions Used in This Guide Xiv About this Guide Introduction For information about Refer toC2RPS-POE Overview Power Classifications and DeploymentC2RPS-POE Status LED Example of a C2RPS-POE Power Configuration Getting Help Support@enterasys.comInstallation Required ToolsContents of N-POE Chassis Carton Quantity Installing the C2RPS-POE on a Flat SurfaceUnpacking the C2RPS-POE Installing the Rubber Feet Guidelines for Installation Guidelines for Rackmount Installation Rack Mounting the C2RPS-POEAttaching Brackets and Installing in Rack C2RPS-POE Status LED Indications and Recommended Actions Connecting C2RPS-POE Cable and AC Power CordColor State Recommended Action C2RPS-POE Cable C2RPS-POE Cable and AC Power Cord Connections Connecting C2RPS-POE Cable and AC Power Cord Installation C2RPS-POE Specifications SpecificationsTable A-1 C2RPS-POE Specifications Electrical Table A-1 C2RPS-POE Specifications Physical C2RPS-POE Redundant Power Supply Output ConnectorEnvironmental Compliance Standards Table A-3 Compliance StandardsCompliance Standards Specifications