Installing
3.Perform a visual inspection of the switch devices for any signs of physical damage. Contact Enterasys Networks if there are any signs of damage. Refer to “Getting Help” on page 1‐5 for details.
Table 2-1 Contents of C2RPS-CHAS2 Carton
Item | Quantity | |
|
|
|
1 |
| |
|
|
|
This guide, SecureStack C2 Installation Guide | 1 |
|
|
|
|
Release Notes | 1 |
|
|
|
|
Table |
|
|
|
| |
Item | Quantity |
|
|
|
|
1 |
| |
|
|
|
USA, NEMA Power Cord | 1 |
|
|
|
|
1 |
| |
|
|
|
Notice Card | 1 |
|
|
|
|
Installing C2RPS-PSMs
Caution: Observe all Electrostatic Discharge (ESD) precautions when handling sensitive electronic equipment.
Precaución: Al trabajar con equipos electrónicos sensibles, tome todas las precauciones de seguridad para evitar descargas de electricidad estática.
When you receive your C2RPS‐CHAS2 chassis, a coverplate will be in place over each power‐supply slot.
To install the PSMs, refer to Figure 2‐1 and proceed as follows:
1.Place the chassis on a sturdy flat surface where you plan to install PSMs.
2.Align the PSM with one of the slots, then slide the PSM forward until its front panel is flush against the chassis front panel.
3.Fasten the PSM to the chassis using the captive screws on the PSM front panel.
4.Repeat steps 2 and 3 for each additional PSM.
5.Proceed to “Installing C2RPS‐CHAS2 into the Rack” on page 2‐4 for the rack mount installation instructions.