EnGenius Technologies EOC2611P manual Mounting Kits, IP Address Configuration

Page 10

EnGenius EOC2611P

Version 1.0

2.3 Mounting Kits

The images below depict the standard mounting kits.

Pole Mount

Wall Mount

Window Mount

2.4 IP Address Configuration

This device can be configured as a Access Point / Client Bridge / WDS Bridge / Client Router. The default IP address of the device is 192.168.1.1. And in order to log into this device, you must first configure the TCP/IP settings of your PC/Notebook.

1.In the control panel, double click Network Connections and then double click on the connection of your Network Interface Card (NIC). You will then see the following screen.

10

Image 10

Contents EOC2611P Table of Contents 1.1 Appendix B IC Statement Version Date Remark Features Introduction Package Contents System RequirementsDifficult‐to‐wire environments ApplicationsHardware Installation Hardware DescriptionIP Address Configuration Mounting KitsEnGenius EOC2611P Version Switching Between Operating Modes LoggingAccess Point Operating Mode Status MainWireless Client List System LogSystem System PropertiesIP Settings Spanning Tree Settings Wireless Wireless NetworkEnGenius EOC2611P Version ` Wireless Security Security Mode WEP EnGenius EOC2611P Version ` Wireless Security Security Mode WPA, WPA2, WPA Mixed Wireless MAC Filter WDS Link Settings Wireless Advanced Settings Administration ManagementManagement Vlan Snmp Settings Backup/Restore settings, Reset to factory default settings Firmware Upgrade Time SettingsDiagnostics 7 LogClient Bridge Operating Mode EnGenius EOC2611P Version Connection Status System IP Settings Spanning Tree Settings Wireless Wireless Security Wireless Security WEP Wireless Security WPA‐PSK Wireless Security WPA2‐PSK Wireless Advanced Settings Management Snmp Settings Backup/Restore settings, Reset to factory default settings Firmware Upgrade 6 Log Diagnostics WDS Bridge Operating Mode EnGenius EOC2611P Version WDS Link Status System IP Settings Spanning Tree Settings Wireless WDS Link Settings WDS Security Wireless Advanced Settings Management Snmp Settings Backup/Restore settings, Reset to factory default settings Firmware Upgrade 6 Log Diagnostics Status Dhcp Client Table Connection Status EnGenius EOC2611P Version System WAN Settings WAN DhcpWAN Static IP WAN PPPoE WAN Pptp EnGenius EOC2611P Version LAN Settings VPN Pass ThroughWireless Wireless Security Wireless Security WPA‐PSK, WPA2‐PSK Wireless Advanced Settings Management Snmp Settings Backup/Restore settings, Reset to factory default settings Firmware Upgrade 6 Log Diagnostics Appendix a FCC Interference Statement Federal Communication Commission Interference StatementIndustry Canada statement Radiation Exposure Statement