EnGenius Technologies EOC2611P manual IP Settings

Page 17

4.3.2 IP Settings

This page allows you to configure the device with a static IP address or a DHCP client.

IP Network Setting: Select Obtain an IP address automatically (DHCP) radio button if the Access Point is connected to a DHCP server. This will allow the Access Point to pass IP addresses to the clients associated with it. You may select Specify an IP Address radio button if you would like the device to use a static IP address. In this case, you would be required to specify an IP address, subnet mask, and default gateway IP address.

IP Address: Specify an IP address

IP Subnet Mask: Specify the subnet mask for the IP address

Default Gateway: Specify the IP address of the default gateway.

Click on the Apply button to save the changes.

Image 17

Contents EOC2611P Table of Contents 1.1 Appendix B IC Statement Version Date Remark Introduction FeaturesSystem Requirements Package ContentsApplications Difficult‐to‐wire environmentsHardware Description Hardware InstallationMounting Kits IP Address ConfigurationEnGenius EOC2611P Version Logging Switching Between Operating ModesAccess Point Operating Mode Main StatusSystem Log Wireless Client ListSystem Properties SystemIP Settings Spanning Tree Settings Wireless Network WirelessEnGenius EOC2611P Version ` Wireless Security Security Mode WEP EnGenius EOC2611P Version ` Wireless Security Security Mode WPA, WPA2, WPA Mixed Wireless MAC Filter WDS Link Settings Wireless Advanced Settings Management AdministrationManagement Vlan Snmp Settings Backup/Restore settings, Reset to factory default settings Time Settings Firmware Upgrade7 Log DiagnosticsClient Bridge Operating Mode EnGenius EOC2611P Version Connection Status System IP Settings Spanning Tree Settings Wireless Wireless Security Wireless Security WEP Wireless Security WPA‐PSK Wireless Security WPA2‐PSK Wireless Advanced Settings Management Snmp Settings Backup/Restore settings, Reset to factory default settings Firmware Upgrade 6 Log Diagnostics WDS Bridge Operating Mode EnGenius EOC2611P Version WDS Link Status System IP Settings Spanning Tree Settings Wireless WDS Link Settings WDS Security Wireless Advanced Settings Management Snmp Settings Backup/Restore settings, Reset to factory default settings Firmware Upgrade 6 Log Diagnostics Status Dhcp Client Table Connection Status EnGenius EOC2611P Version System WAN Dhcp WAN SettingsWAN Static IP WAN PPPoE WAN Pptp EnGenius EOC2611P Version VPN Pass Through LAN SettingsWireless Wireless Security Wireless Security WPA‐PSK, WPA2‐PSK Wireless Advanced Settings Management Snmp Settings Backup/Restore settings, Reset to factory default settings Firmware Upgrade 6 Log Diagnostics Federal Communication Commission Interference Statement Appendix a FCC Interference StatementRadiation Exposure Statement Industry Canada statement