EnGenius Technologies EOC2611P manual Wireless

Page 78

EnGenius EOC2611P

Version 1.0

7.5 Wireless

Under the Wireless section of the left menu, you will see the following options: Wireless Network, Wireless Security, and Wireless Advanced Settings. Each option is described below.

7.5.1 Wireless Network

The Wireless Network page allows you to configure the Wireless Mode, Channel, SSID, and Security Settings.

Wireless Mode: Depending on the type of wireless clients that are connected to the network, you may select B, G, B/G‐mixed or Super‐G. If you are not sure about which clients will be accessing the wireless networks, it is recommended that you select B/G‐mixed for the best performance.

SSID: The SSID is a unique named shared amongst all the points of the wireless network. The SSID must be identical on all points of the wireless network and cannot exceed 32 characters. You may specify an SSID or select one from the Site Survey.

Site Survey: Click on the Site Survey button in order to scan the 2.4GHz frequency for devices that broadcast their SSID. Click on the BSSID link to connect to the Access Point. Click on the Refresh button to re‐scan the frequency.

78

Image 78

Contents EOC2611P Table of Contents 1.1 Appendix B IC Statement Version Date Remark Features IntroductionPackage Contents System RequirementsDifficult‐to‐wire environments ApplicationsHardware Installation Hardware DescriptionIP Address Configuration Mounting KitsEnGenius EOC2611P Version Switching Between Operating Modes LoggingAccess Point Operating Mode Status MainWireless Client List System LogSystem System PropertiesIP Settings Spanning Tree Settings Wireless Wireless NetworkEnGenius EOC2611P Version ` Wireless Security Security Mode WEP EnGenius EOC2611P Version ` Wireless Security Security Mode WPA, WPA2, WPA Mixed Wireless MAC Filter WDS Link Settings Wireless Advanced Settings Administration ManagementManagement Vlan Snmp Settings Backup/Restore settings, Reset to factory default settings Firmware Upgrade Time SettingsDiagnostics 7 LogClient Bridge Operating Mode EnGenius EOC2611P Version Connection Status System IP Settings Spanning Tree Settings Wireless Wireless Security Wireless Security WEP Wireless Security WPA‐PSK Wireless Security WPA2‐PSK Wireless Advanced Settings Management Snmp Settings Backup/Restore settings, Reset to factory default settings Firmware Upgrade 6 Log Diagnostics WDS Bridge Operating Mode EnGenius EOC2611P Version WDS Link Status System IP Settings Spanning Tree Settings Wireless WDS Link Settings WDS Security Wireless Advanced Settings Management Snmp Settings Backup/Restore settings, Reset to factory default settings Firmware Upgrade 6 Log Diagnostics Status Dhcp Client Table Connection Status EnGenius EOC2611P Version System WAN Settings WAN DhcpWAN Static IP WAN PPPoE WAN Pptp EnGenius EOC2611P Version LAN Settings VPN Pass ThroughWireless Wireless Security Wireless Security WPA‐PSK, WPA2‐PSK Wireless Advanced Settings Management Snmp Settings Backup/Restore settings, Reset to factory default settings Firmware Upgrade 6 Log Diagnostics Appendix a FCC Interference Statement Federal Communication Commission Interference StatementIndustry Canada statement Radiation Exposure Statement