EnGenius Technologies EOC2611P manual Firmware Upgrade

Page 85

EnGenius EOC2611P

Version 1.0

7.6.4 Firmware Upgrade

This page is used to upgrade the firmware on the device. Make sure that downloaded the appropriate firmware from your vendor.

Click on the Browse button and then select the appropriate firmware and then click on the Upgrade button.

Note: The upgrade process may take about 1 minute to complete. Do not power off the device during this process as it may crash the device and make it unusable. The device will restart automatically once the upgrade is complete.

7.6.5 Time Settings

Click on the Time Settings link under the Management menu. This page allows you to configure the time on the device. You may do this manually or by connecting to a NTP server.

Manually Set Date and Time: Specify the date and time

Automatically Get Date and Time: Select the time zone from the drop down list and then specify the IP address of the NTP server.

Click on the Apply button to save the changes.

85

Image 85

Contents EOC2611P Table of Contents 1.1 Appendix B IC Statement Version Date Remark Introduction FeaturesSystem Requirements Package ContentsApplications Difficult‐to‐wire environmentsHardware Description Hardware InstallationMounting Kits IP Address ConfigurationEnGenius EOC2611P Version Logging Switching Between Operating ModesAccess Point Operating Mode Main StatusSystem Log Wireless Client ListSystem Properties SystemIP Settings Spanning Tree Settings Wireless Network WirelessEnGenius EOC2611P Version ` Wireless Security Security Mode WEP EnGenius EOC2611P Version ` Wireless Security Security Mode WPA, WPA2, WPA Mixed Wireless MAC Filter WDS Link Settings Wireless Advanced Settings Management AdministrationManagement Vlan Snmp Settings Backup/Restore settings, Reset to factory default settings Time Settings Firmware Upgrade7 Log DiagnosticsClient Bridge Operating Mode EnGenius EOC2611P Version Connection Status System IP Settings Spanning Tree Settings Wireless Wireless Security Wireless Security WEP Wireless Security WPA‐PSK Wireless Security WPA2‐PSK Wireless Advanced Settings Management Snmp Settings Backup/Restore settings, Reset to factory default settings Firmware Upgrade 6 Log Diagnostics WDS Bridge Operating Mode EnGenius EOC2611P Version WDS Link Status System IP Settings Spanning Tree Settings Wireless WDS Link Settings WDS Security Wireless Advanced Settings Management Snmp Settings Backup/Restore settings, Reset to factory default settings Firmware Upgrade 6 Log Diagnostics Status Dhcp Client Table Connection Status EnGenius EOC2611P Version System WAN Dhcp WAN SettingsWAN Static IP WAN PPPoE WAN Pptp EnGenius EOC2611P Version VPN Pass Through LAN SettingsWireless Wireless Security Wireless Security WPA‐PSK, WPA2‐PSK Wireless Advanced Settings Management Snmp Settings Backup/Restore settings, Reset to factory default settings Firmware Upgrade 6 Log Diagnostics Federal Communication Commission Interference Statement Appendix a FCC Interference StatementRadiation Exposure Statement Industry Canada statement