Connecting to the Network
2.Insert the MT‐RJ cable connector into the MT‐RJ front panel port until it clicks into place.
Note: To remove the
Figure 3-15 Connecting a Fiber-Optic Cable Segment to MT-RJ Port
1 | 3 |
|
| 5 | |
|
| |
2 |
| 7 |
4 | 9 | |
| 6 | |
|
| |
|
| 8 |
|
| 10 |
Â
11 | 13 |
|
|
|
|
|
| 15 |
|
|
|
| |
|
| 17 |
|
|
| |
12 |
|
| 19 |
|
| |
14 |
|
| 21 |
| ||
| 1 |
|
| 23 | ||
|
| 6 | 18 |
|
| |
|
|
| 20 |
|
| |
|
|
|
| 22 |
| |
|
|
|
|
| 24 | |
|
|
|
|
|
|
Á
À
1 3 5
7 2
9 4
11 6
10 12
1 | 3 Front panel Port Link/Activity LED | |
2 |
|
3.Verify that a link exists by checking that the Link/Activity LED is ON (solid green or blinking green). If the Link/Activity LED is OFF, perform the following steps until it is on:
a.If there are separate fiber‐optic connections on the other device, check the crossover of the cables. Swap the cable connections if necessary.
b.Verify that the fiber connection meets the dB loss and cable specifications for multimode cabling, as outlined in the Cabling Guide. Refer to “Related Documents” on page xvi for information on obtaining this document.
4.If a link is not established, contact Enterasys Networks. Refer to “Getting Help” on page 1‐6 for details.
Repeat all steps above until all connections have been made.
SecureStack A2 Installation Guide