Connecting to the Network
Connecting Fiber-Optic Cables to MT-RJ Mini-GBIC Ports
Warning:
Advertencia: Los
Warnhinweis:
This section contains the procedures for connecting a 1000BASE‐SX multimode fiber‐optic segment from the network or other device to an MT‐RJ port connector in a Mini‐GBIC (MGBIC‐MT01).
Each fiber‐optic link consists of two fiber‐optic strands within the cable:
•Transmit (TX)
•Receive (RX)
The transmit strand from the MT‐RJ port connects to the receive port of a fiber‐optic Gigabit Ethernet device at the other end of the segment. The receive strand of the applicable MT‐RJ port connects to the transmit port of the fiber‐optic Gigabit Ethernet switch.
Enterasys Networks recommends labeling fiber‐optic cables to indicate receive and transmit ends. Many cables are pre‐labeled, providing matching labels or tapes at both ends of each strand of cable.
To connect an MT‐RJ cable to a fixed MT‐RJ connector of a Mini‐GBIC:
1.Remove the protective covers from the Mini‐GBIC MT‐RJ fiber‐optic port and from the connectors on each end of the cable.
Note: Leave the protective covers in place when the connectors are not in use to prevent contamination.