Redundancy
To establish a daily time of day for a test:
1.In the upper right hand corner of the Redundancy Configuration window, click on the gray box to the right of the Test Time of Day text box. The Test Time of Day window, Figure
Figure 7-7. Test Time of Day Window
2.Using the mouse, click to highlight the hour field in the New Timer Interval text box.
3.Using the arrow keys to the right of the text box, scroll to change the hour, as desired.
4.Using step 2 and 3, continue to change the minutes and seconds fields as desired (the default value is 1:00:00 a.m.).
5.Click 
to accept the new time, or click Cancel to exit the window without accepting any changes.
To perform an immediate test of all circuits:
1.Click Test in the Redundancy Configuration window. All configured circuits will be tested immediately.
Reconfiguring a Circuit
Once a circuit is enabled, the redundancy scheme will operate automatically. However, you may wish to alter its configuration after it is initially enabled. You can alter the Circuit Name or Retry Count, as described in previous sections, while a circuit is enabled. However, to change the port status or address information of an enabled circuit, you must first disable it.
To do so:
1.Use the
2.Click Configure, and drag down to Disable to inactivate the currently selected circuit. The displayed status for the selected circuit will change to Disabled.
Reconfiguring a Circuit |