Enterasys Networks B3G124-48P, B3G124-24P manual Troubleshooting, Using Lanview

4

Troubleshooting

This chapter provides information concerning the following:

For information about...	Refer to page...
Using LANVIEW	4-1
Troubleshooting Checklist	4-7
Using the Reset Switch	4-8

This device contains a battery that is not considered a user replaceable part. If the battery needs to be replaced, contact customer service for repair.

Caution: There is a risk of explosion if the battery is replaced with an incorrect type. A used battery may be safely disposed in a municipal waste stream.

Precaucion: Hay riesgo de explosion si la bateria se reemplaza con el typo incorrecto. Puede tirar la bateria usada en la basura

Using LANVIEW

The switch uses the Enterasys Networks built‐in visual diagnostic and status monitoring system called LANVIEW. For the location of LANVIEW LEDs on the B3G124‐24P and B3G124‐48P, refer to Figure 4‐1 and Figure 4‐2, respectively. These LEDs allow you to quickly observe network status for diagnosing switch and network problems.

SecureStack B3 Installation Guide 4-1