Eaton Electrical 6000L(XL), 10000L(XL) user manual Option

Page 10

Connection Details of Output Terminals

Important Note: If the UPS is used in Single Mode, JP1 and JP2 must be connected by 10AWG (6mm2). If the UPS is used in Parallel Mode, the Jumper between JP1 and JP2 must be removed.

●Option: 1

Connection Details of Output Terminals.

Connect Output Line 1 and Output Neutral 1 for 120V / 3KVA Load or connect by 10AWG (6mm2). Output Line 2 and Output Neutral 2 for 120V / 3KVA Load.

Image 10

Contents Uninterruptible Power Supply Contents Brief introduction Description of commonly used symbolsSystem and model description Appearance Nation and ExplanationPage Electrical performance Installation Unpacking and inspectionPage Page Option Option Page Parallel operation Operation and Operating mode OperationPage Operating mode Function Page RS232 interface GND Battery maintenance Replacement Troubleshooting Problem Possible cause SolutionUPS Set the bypass breaker in on position Appendix 1： display panel Appendix 2： The corresponding form of the LED Display Page 614-03753-01