Eaton Electrical 10000L(XL), 6000L(XL) user manual Set the bypass breaker in on position

The #1 Fault LED
and the battery LED	The charger of	Please contact the distributor or service
are turned on, the	the UPS is
		center.
buzzer beeps every	defective.
second
	Battery low or	Check the battery. If the battery is
		damaged, replace the battery
Battery LED flashes	battery not
		immediately and ensure that the battery
	connected
		breaker is in “ON” position.
The utility power is
normal, but the UPS	Bypass breaker	Set the bypass breaker in “ON” position.
can not turn in line	in “OFF” position
mode
	Battery not yet	Keep UPS connected to utility power
	been fully	persistently for more than 10 hours to
	charged	recharge the batteries again.
Battery discharging	UPS overloaded	Check the loads and remove the
time diminishes		non-critical equipment.
		Replace the batteries. Please contact
	Battery aged	the distributor to obtain the parts and
		replacement service.
	The “ON” button	Press the “ON” button for more than 1
	is pressed too
		second.
	briefly
The UPS cannot	The UPS is not
	connected to the
power on after
	battery or the	Check the battery or recharge the
pressing the ON
	battery pack	battery.
button
	voltage is too
	low.
	UPS fault	Please contact the distributor or service
		center.

When you contact the service center, please provide the following information:

●Model No. and the serial No. of the UPS;

●The date when the problem arose;

●Complete description of the problem, including the LED display, alarm warning, and power condition and load capacity. If your UPS is a long backup time model, you may also provide the battery information.

23